535673
10
Zoom out
Zoom in
Previous page
1/20
Next page
2QuickScan
TM
QS6500BT
8. Place the linear imager in the Base Station and verify the
charge LED is flashing. After five minutes, the scanner will
have sufficient charge to begin reading labels. A full charge
from depleted battery will take approximately 2 hours.
9. Press and hold the link button on the bottom of the Base
Station for three seconds. This will ensure that any other
imager link to the Base Station will be broken. Upon unlink-
ing, the Base Station will sound a short beep, followed by
two longer beeps, accompanied by a flashing amber LED.
10.Scan the bar code located on the label applied to the back
face of the Base Station. This will “link” the linear imager to
the Base Station. Upon successful link (which can take a few
seconds), the imager will sound a low-to-high pitched beep.
11.To verify scanning operation, point the linear imager at a bar
code and pull the trigger. The linear imager should emit a
beep indicating that the label has been scanned and transmit-
ted to the Base Station successfully.
The linear imager installation is complete.
NOTE
A momentary press of the link button can be used to later
verify a link between the imager and Base Station. A good
link is indicated by six short beeps. The Base Statioin notes
an unlinked situation by slowly flashing an amber LED.
11
10
10


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Datalogic QuickScan QS6500BT at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Datalogic QuickScan QS6500BT in the language / languages: English as an attachment in your email.

The manual is 1,53 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Datalogic QuickScan QS6500BT

Datalogic QuickScan QS6500BT User Manual - English - 336 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info