535578
17
Zoom out
Zoom in
Previous page
1/36
Next page
Mounting the Scanner
Integration Guide 13
Good Read Beep Interface
The Beep Interface connection (J3) provides the integrator a means to
tap the engine's good read beep signaling and interface with an external
audio device.
The Beep Connection (J3) is a Molex part number, 53261-0271,
1.25mm Pitch PicoBlade™ 2 Circuit Header. To attach to this SMT
Right Angle Header, the integrator should use the Molex mating plug,
51021-0200 and wire crimp terminal, 50079-8000 or equivalent.
Table 3. J3 Connector Pin Assignment
The Good Read Beep is a 2750Hz signal burst for 100ms provided by an
on board Open Collector transistor drive circuit. Below is a simple exam-
ple of an external audio implementation which calls out a readily avail-
able Magnetic Audio Buzzer. Any other type of audio-producing element
may require a custom interface and drive circuitry. See
"Technical Speci-
fications"
on page 19 for additional information about Good Read Beep
output.
Pin Pin Functionality
1 Good Read Beep Signal (open collector, active low)
2Common (gnd)
17


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Datalogic Gryphon I GFE4400 2D at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Datalogic Gryphon I GFE4400 2D in the language / languages: English as an attachment in your email.

The manual is 2,91 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info