465416

Danfoss TP5001Range installatie Manual

67
Zoom out
Zoom in
Previous page
1/92
Next page
67
RX1
RX2 et RX3
12
3
4
Electronique
N
L
COM
Zone 1
Marche
Zone 1
Arrét
A
Electronique
B
C1
2
345
6
N
L
Zone 1
Marche
Zone 1
Arrêt
Zone 2
Marche
Zone 3
Marche
COM
Borne 6 RX3
uniquement
Câblage du récepteur RX (modèles RF uniquement)
1) Pour les systèmes à alimentation secteur, relier la borne 2 à la tension.
2) L’alimentation électrique du thermostat ne doit pas être activée par un
temporisateur.
IMPORTANT
Pour s’assurer un retour au programmes d’usine et réinitialiser
le processeur , il est essentiel de maintenir pendant quelques
secondes le bouton RESET avant toute programmation.
Mise en service (modèles RF uniquement)
Si le thermostat et le récepteur ont été livrés en un seul ensemble,
les unités ont été couplées en usine et aucune mise en service n’est
nécessaire (RX1 uniquement).
Pour coupler manuellement le récepteur au thermostat émetteur , suivre
les cinq étapes suivantes.
Etape 1 TP5001-RF
Remettre le thermostat à zéro en appuyant sur
le bouton de remise à zéro encastré.
Etape 2 Appuyer et maintenir enfoncées les
touches V et + pendant 3 secondes (le TP5001
RF Si émet alors un signal unique en continu
pendant 3 minutes)
Instructions d’installation
F
… 67 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Danfoss TP5001Range installatie at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Danfoss TP5001Range installatie in the language / languages: English, German, Dutch, Danish, French, Italian, Spanish as an attachment in your email.

The manual is 3,88 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info