465428
25
Zoom out
Zoom in
Previous page
1/31
Next page
6.3 Niveau van het brinecircuit controleren
Het brinecircuit moet zijn gevuld met de juiste hoeveelheid vloeistof,
omdat er anders bedrijfsstoringen kunnen ontstaan.
De brinevloeistof moet worden bijgevuld als het niveau van de vloeistof
zo ver daalt, dat deze niet meer te zien is in het expansievat.
Legenda
1
2
Afbeelding 1. Niveau,
brinevloeistof
1 Correct niveau
2 Te laag niveau
De eerste maand na de start van de installatie kan het niveau van de bri-
nevloeistof iets dalen. Dat is normaal. Het vloeistofniveau kan ook varië-
ren door de temperatuur in de warmtebron, maar het vloeistofniveau
mag onder geen beding zo ver dalen dat deze niet meer te zien is in het
expansievat.
Voor DHP-A met op druk gebracht brinecircuit geldt dat de manometer
van het expansievat ca. 1,0 bar moet aangeven.
Neem voor het bijvullen van brinevloeistof altijd contact op met uw
installateur.
6.4 Veiligheidskleppen controleren
De twee veiligheidskleppen van de installatie moeten minimaal vier
keer per jaar worden gecontroleerd om te voorkomen dat het mecha-
nisme verstopt raakt door kalkafzetting.
De veiligheidsklep van de boiler beschermt tegen overdruk in de geslo-
ten boiler. Deze is op de koudwaterinlaat gemonteerd met de uitloop
naar beneden. Als de veiligheidsklep van de boiler niet regelmatig
wordt gecontroleerd, bestaat het gevaar dat de boiler beschadigd raakt.
Het is normaal dat er bij het opladen van de boiler kleine hoeveelheden
water uit de veiligheidsklep komen, met name bij verbruik van grote
hoeveelheden warm water.
Gebruikershandleiding VUBMA910 – 23
25


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Danfoss DHP-H Opti at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Danfoss DHP-H Opti in the language / languages: Dutch as an attachment in your email.

The manual is 1,46 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info