562741
8
Zoom out
Zoom in
Previous page
1/26
Next page
10
10.0 CONNECTION
Always turn off your amplifier/subwoofer before connecting any cables or altering any connections.
We recommend using special speaker and signal cables. Consult your authorized DALI dealer
for guidance on selection of speaker and signal cables. Use same type cable for all speakers in
the setup (except for the subwoofer). Make sure to connect the correct amplifier output to the
correct speaker – see Figure 5A - C for stereo/surround sound setups. Make sure to connect
the positive amplifier output terminal (red) to the positive speaker input terminal (red) and the
negative
amplifier output terminal (black) to the negative speaker input terminal (black), see Figure 6. If
just one speaker is incorrectly connected, the bass might be weak and the overall sound might
be diffuse.
Make sure that there are no loose cable strands/ends which potentially can short circuit
and damage the amplifier, see Figure 7. The binding posts accept bare cable ends or 4mm
banana plugs.
11.0 LEKTOR SUB
LEKTOR SUB is an active subwoofer with built-in amplifier. On the bottom of the subwoofer
there is a bass reflex port opening. Make sure that the rubber feet will make clearance between
the floor and the bottom of the subwoofer, so that air can flow freely from the bass reflex port.
On the rear side of the subwoofer you will find the amplifier (see Figure 8), which have the
following features:
1) Line In L + R, connect your stereo or surround sound amplifier to these inputs using a RCA
cable (sold separately). Adjustment of “Phase”, “Crossover” and “Volume” must be done on
the subwoofer. You might also want to use connection through the LFE input (see point 2).
2) LFE In, connect your surround sound amplifier to this input using a RCA cable (sold
separately). Adjustment of “Crossover” must be done in the surround sound amplifier.
3) Auto selector: On: the subwoofer is always on when the power switch (9) is on. Auto: the
subwoofer will power up upon detection of an input signal on the “Line In” inputs (1 +
2). The subwoofer will power down after approximately 20 minutes with no input signal
present on the input connectors. Off: the subwoofer will be powered down.
4) “Volume” adjustment: Start adjusting the volume of your subwoofer so the bass level
matches the level from the main speakers (with the Crossover (5) knob in the middle
position and Phase switch (6) in the 180° setting). Adjust the level so the contribution from
the subwoofer is firm and precise - but without the bass being too dominant. If you adjust
the volume level too high, your total sound experience may be disturbed by distortion.
Remember that the location of the subwoofer/listening position has a major effect on the
sound pressure you experience.
8


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Dali LEKTOR at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Dali LEKTOR in the language / languages: English as an attachment in your email.

The manual is 2,45 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info