562740
14
Zoom out
Zoom in
Previous page
1/38
Next page
16
9.9 POWER
The POWER switch is the main ON/OFF switch. We recommend switching OFF the subwoofer
when it is not to be used for extended periods. When the POWER switch is set to OFF there
will still be voltage inside the subwoofer. If you completely disconnect the subwoofer from the
mains voltage, please be sure to remove the mains plug from the subwoofer. When changing
connections, always disconnect the mains voltage from the subwoofer. We recommend that you
ALWAYS turn OFF the POWER switch on the rear side of the subwoofer BEFORE turning off the
mains switch.
9.10 ON/STAND BY
The subwoofer has a built-in circuit that will power up the amplifier of the subwoofer when an
input signal is detected (given that the POWER is set to ON and the power mode switch is set to
AUTO). When the subwoofer is ON, the ON/STANDBY LED will light up green. If an input signal is
not detected for approximately 20 minutes, the subwoofer will go into standby mode and the ON/
STANDBY LED on the rear of the subwoofer will light up red.
9.11 OVERLOADING
If DALI IKON SUB is overloaded, the built-in safety circuit may power down the subwoofer. The
subwoofer will power on again when the temperature of the built-in amplifier is within safe
working range.
If overloaded, we recommend that you turn off the subwoofer for a few minutes before turning it
on again.
NOTE: The built-in safety circuit is no guarantee against damage as a result of overloading.
9.12. AMPLIFIER BACK PLATE (see figure 10)
A) ON/STANDBY LED, indicator is green when POWER is set to ON or when an input signal is
detected. The LED is red, if the subwoofer is in standby mode.
B) VOLUME adjustment: Turn the control towards “Max” to increase the sound level. To reduce
the sound level, turn the control towards “Min”.
C) CROSSOVER: Adjustment of the crossover frequency from 50 Hz to 130 Hz.
D) Toggle the PHASE of the subwoofer to either 0 degrees or 180 degrees phase angle.
E) LINE input: Connect the “L input connector (white) to the LEFT RCA line output connector
of your stereo/surround sound (pre-) amplifier. Connect the “R” input connector (red) to the
RIGHT RCA line output connector of your stereo/surround sound (pre-) amplifier.
F) LFE input: Connect the “LFE” input connector (black) to the LFE RCA line output of your
surround sound amplifier.
G) POWER switch: Set the switch to ON to power up the subwoofer. Set the switch to OFF to
power off the subwoofer.
14


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Dali IKON MK2 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Dali IKON MK2 in the language / languages: English as an attachment in your email.

The manual is 3,28 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Dali IKON MK2

Dali IKON MK2 User Manual - English, German, Danish - 38 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info