643443
9
Zoom out
Zoom in
Previous page
1/1009
Next page
GENERAL SERVICE INSTRUCTION
1. Use fender covers, seat covers and floor sheets so that the vehicle may not get dirty or be scratched.
2. Jacking up
(1) When only the front section or rear section of the vehicle is jacked up, be sure to place chocks at
the wheels so as to insure safe operations.
(2) When the vehicle has been jacked up, be sure to support the vehicle at the specified section using
safety stands. (See page GI–9)
3. Handling instructions related to battery.
(1) Before you start performing the electrical works, make certain to disconnect the battery ground
cable terminal from the negative (–) terminal of the battery.
NOTE:
Before disconnecting the battery ground cable terminal from the negative (–) terminal of the battery,
be sure to read out the diagnosis code of the EFI, Airbag and immobilizer system etc., if the vehicle
is equipped with such systems, when necessary.
After reconnecting the battery ground cable terminal to the negative terminal of the battery, be sure to
reset the watch or radio, if the vehicle is equipped with such equipment.
(2) When it becomes necessary to disconnect the battery power supply for the purpose of carrying out
checks or repairs, always disconnect the battery ground cable terminal from the negative terminal
of the battery first.
(3) To avoid damaging battery plates, after the terminal nut has been loosened, pull out the battery
ground cable terminal straight upward, rather than turning or prying the terminal.
NOTE:
Be sure to employ a battery terminal puller (commercially available) to remove the battery ground
cable terminal from the negative terminal of the battery, if encountered any difficulty.
(4) Clean the battery terminal posts or battery ground terminals, using a cloth. Never use a file or other
adhesive agents.
(5) When connecting the battery ground cable terminal to the battery, first the battery ground cable ter-
minal should be fitted onto the battery post with the attaching nut in a loose state.
Then, tighten the nut. Never tap the terminal onto the battery post, using a hammer or spanner wrench
or the like.
(6) As for the cover at the positive (+) terminal side, be sure to install it at the correct position.
4. Repairs of fuel system
(1) The EFI equipped vehicles employ a high fuel pressure. Therefore, the following notes should be
observed.
q Be sure to prevent the fuel from splashing with a cloth or the like, when the union bolt or other
connected section of the fuel line is loosened or slackened.
(2) When connecting/disconnecting the fuel line.
q Tighten each connecting section to the specified torque.
w Attach new specified clips to each connecting section.
e Be certain to place a suitable container or a cloth, etc. under the connected section of the fuel
line before disconnecting the fuel line.
r Before the fuel line is disconnected, be sure to release the inner pressure of the fuel tank by
detaching the fuel filler cap.
t Be sure to follow the instruction mentioned in the main text when disconnect or connect the
quick type connectors.
(3) Never work near open flames.
5. For increased work efficiency and improved accuracy, be sure to utilize SSTs (Special Service Tools) ef-
fectively.
GI–7
JGI00008-00000
9


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Daihatsu Terions J100 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Daihatsu Terions J100 in the language / languages: English as an attachment in your email.

The manual is 41,47 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info