Manual Daewoo KOC 984T (page 2 of 9) (English)

456788

Zoom out

Zoom in

1/9

CONTENTS

INSTALLATION AND EARTHING INSTRUCTIONS 2

IMPORTANT SAFETY INSTRUCTIONS 3

WHICH UTENSILS CAN BE USED IN THE OVEN? 4

CONTROL PANEL 5

ACCESSORIES 6

HOW TO SET THE OVEN CONTROLS 7

GENERAL GUIDELINES 12

KEEP THE OVEN CLEAN 13

BEFORE CALLING FOR SERVICE 14

QUESTIONS AND ANSWERS 15

SPECIFICATIONS 15

PRECAUTIONS TO AVOID POSSIBLE EXPOSURE

TO EXCESSIVE MICROWAVE ENERGY

(1) Do not attempt to operate this oven with the door open since open-door operation can result

in harmful exposure to microwave energy. It is important not to override or tamper with the safety

interlocks.

(2) Do not place any object between the oven front face and the door, or allow food particles or

cleaner residue to accumulate on sealing surfaces.

(3) Must not be operated the oven if it is damaged. It is particularly important that the oven door

close properly and that there is no damage to the:

(1) Door (bent), (2) hinges and latches (broken or loosened), (3) door seals and sealing surfaces.

(4) The oven should not be adjusted or repaired by anyone except properly qualified service

personnel.

It is hazardous for anyone other than a trained person to carry out any service or repair operation

which involves the removal of any cover which gives protection against exposure to microwave

energy.

INSTALLATION AND EARTHING INSTRUCTIONS

How to examine your microwave oven after unpacking.

Unpack oven, remove all packing material, and examine the

oven for any damage such as dents, broken door, latches or

cracks in the door. Do not remove the film from inside the door.

Notify dealer immediately if the oven is damaged. Do not install if

the oven is damaged.

Where to place your microwave oven.

1. Place the oven on a flat and stable surface.

2. Surface of the oven is protected by a plastic film which should

be removed before using.

3. Leave space behind and sides and upper of the oven. All air

vents should be kept a clearance.

If all vents are covered during operation, the oven may

overheat and, eventually, lead to oven failure.

4. Keep away from radio and TV sets. If the oven is located

close to a TV, radio interference may result.

5. Keep away from heating appliances and water taps. Keep the

oven away from hot air, steam or splash when choosing a

place to position it, or the insulation might be adversely

affected and breakdowns occur.

6. The minimum height of free space necessary above the top

surface of the oven is minimum 150mm.

Prior to use (If your oven has a grill element)

In order to protect your oven during transportation and storage,

the grill element is covered with a protective coating. To remove

this coating the grill element must be heated for 5 minutes.

This procedure will produce some bad odours as the protective

coating on the element disappears.

To remove the coating, use the following procedures:

1. Place an overproof and microwave safe bowl, containing

200cc of water or more, in the oven.

2. Press the °C Temp button.

3. Set the time to 5 minutes.

4. Press the start button.

5. When the 5 minutes has elapsed, an acoustic signal sounds.

Note:

The protective coating has now been removed and the oven is

ready to use. Please be aware that your oven now is very hot.

6. Open the oven door and remove the bowl with water (use

oven gloves when removing the bowl).

CHILD LOCK

To prevent child from operating the oven, install the childlock

key.

1. Touch stop button for 3 seconds.

"LOC" will show in the display and all buttons do not operate.

2. Touch stop button for 3 seconds once again, then childlock is

canceled.

- WARNING: Only allow children to use the oven without

supervision when adequate instructions have been given so that

the child is able to use the oven in a safe way and understands

the hazards of improper use.

Electrical Connection

WARNING-THIS APPLIANCE MUST BE EARTHED.

REFER TO RATING PLATE FOR VOLTAGE AND CHECK

THAT THE APPLIANCE VOLTAGE CORRESPONDS WITH

THE SUPPLY VOLTAGE IN YOUR HOME.

The flexible mains lead must be correctly connected, as below,

to a three pin plug of not less than 13 AMP capacity. You must

use a 3 pin plug which should be marked with the number BS

1363 and it should be fitted with 13 AMP fuse marked with the

number BS 1362.

We recommend the use of good quality plugs and wall sockets

that can be switched off when the machine is not in use.

IMPORTANT-The wires in the mains lead fitted to this appliance

are coloured in accordance with the following code

GREEN AND YELLOW-EARTH

BLUE-NEUTRAL

BROWN-LIVE

As the colour of the wires in the mains lead of this appliance

may not correspond with the coloured markings identifying the

terminals in your plug, proceed as follows:

Power supply

ƒUCheck your local power source. This oven requires a current

of approximately 12(8)amperes, 230V 50Hz.

ƒUPower supply cord is about 1.2 meters long.

ƒUThe voltage used must be the same as specified on this oven.

Using a higher voltage may result in a fire or other accident

causing oven damage. Using low voltage will cause slow

cooking. We are not responsible for damage resulting from

use of this oven with a voltage of ampere fuse other than

those specified.

ƒUIf the supply cord is damaged, it must be replaced by the

manufacturer or its service agent or a similarly qualified

person in order to avoid a hazard.

The wire which is coloured GREEN AND YELLOW must be

connected to the terminal in the plug which is marked with the

letter "E" or the earth symbol or coloured GREEN AND

YELLOW, or GREEN.

The wire which is coloured BLUE must be connected to the

terminal which is marked with the letter "N" or coloured BLACK,

or BLUE.

The wire which is coloured BROWN must be connected to the

terminal which is marked with the letter "L" or coloured RED , or

BROWN.

If the terminals in the plug are unmarked or you are in any doubt

as to the correct connections, consult a qualified electrician.

If you do not make the proper electrical connections you will

damage your microwave oven and possibly injure yourself.

Neither the manufacturer nor the supplier are liable if this

happens.

MOULDED PLUGS

Should it be necessary to remove a moulded on plug from the

mains cable, it should be cut off and replaced with a suitable

replacement.

The moulded plug cannot be used for any other appliance,

therefore remove the fuse and dispose immediately and safely to

prevent anyone, especially children from plugging it in to a wall

socket, which will create a safety hazard.

Should the mains lead ever require replacement, it is essential

that this operation be carried out by a qualified electrician and

should only be replaced with a flexible cord obtained from the

manufacturer.

Applicable only if moulded plug is fitted.

After replacement of a fuse in the plug, the fuse cover must be

refitted. If the fuse cover is lost, a replacement cover is obtained.

The colour of the correct replacement fuse cover is that of the

coloured insert in the base of the plug or the colour that is

embossed in words in the base of the plug recess or elsewhere

on the plug. Always state this colour when ordering a

replacement fuse cover.

Only 13 amp replacement fuses which are ASTA approved to

BS 1362 should be fitted

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Daewoo KOC 984T in the language / languages: English as an attachment in your email.

The manual is 0,17 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Daewoo KOC 984T

Daewoo KOC 984T User Manual - German - 23 pages

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Daewoo KOC 984T Manual

Product: