»E
lectrical Connection
WARNING-THIS APPLIANCE MUST BE EARTHED.
REFER TO RATING PLATE FOR VOLTAGE AND CHECK THAT
THE APPLIANCE VOLTAGE CORRESPONDS WITH THE SUPPLY
VOLTAGE IN YOUR HOME.
The exible mains lead must be correctly connected, as below,
to a three pin plug of not less than 13 AMP capacity. You must
use a 3 pin plug which should be marked with the number BS
1363 and it should be ed with 13 AMP fuse marked with
the number BS 1362. We recommend the use of good quality
plugs and wall sockets that can be switched o when the
machine is not in use.
Power supply
• Check your local power source. This oven requires a current
of approximately 15amperes, 240V 50Hz.
• Power supply cord is about 1.2 meters long.
• The voltage used must be the same as specied on this
oven. Using a higher voltage may result in a re or other
accident causing oven damage. Using low voltage will cause
slow cooking. We are not responsible for damage resulng
from use of this oven with a voltage of ampere fuse other
than those specied.
• If the supply cord is damaged, it must be replaced by the
manufacturer or its service agent or a similarly qualied
person in order to avoid a hazard.
IMPORTANT-The wires in the mains lead ed to this
appliance are coloured in accordance with the following code
GREEN AND YELLOW-EARTH
BLUE-NEUTRAL
BROWN-LIVE
As the colour of the wires in the mains lead of this appliance
may not correspond with the coloured markings idenfying
the terminals in your plug, proceed as follows:
The wire which is coloured GREEN AND YELLOW must be
connected to the terminal in the plug which is marked with
the leer "E" or the earth symbol or coloured GREEN AND
YELLOW, or GREEN.
The wire which is coloured BLUE must be connected to the
terminal which is marked with the leer "N" or coloured
BLACK, or BLUE.
The wire which is coloured BROWN must be connected to the
terminal which is marked with the leer "L" or coloured RED ,
or BROWN.
If the terminals in the plug are unmarked or you are in any
doubt as to the correct connecons, consult a qualied
electrician.
If you do not make the proper electrical connecons you will
damage your microwave oven and possibly injure yourself.
Neither the manufacturer nor the supplier are liable if this
happens.
MOULDED PLUGS
Should it be necessary to remove a moulded on plug from the
mains cable, it should be cut o and replaced with a suitable
replacement.
The moulded plug cannot be used for any other appliance,
therefore remove the fuse and dispose immediately and
safely to prevent anyone, especially children from plugging it
in to a wall socket, which will create a safety hazard.
Should the mains lead ever require replacement, it is essenal
that this operaon be carried out by a qualied electrician and
should only be replaced with a exible cord obtained from the
manufacturer.
Applicable only if moulded plug is ed.
Aer replacement of a fuse in the plug, the fuse cover must
be reed. If the fuse cover is lost, a replacement cover is
obtained. The colour of the correct replacement fuse cover is
that of the coloured insert in the base of the plug or the colour
that is embossed in words in the base of the plug recess or
elsewhere on the plug. Always state this colour when ordering
a replacement fuse cover. Only 13 amp replacement fuses
which are ASTA approved to BS 1362 should be ed
