72507
26
Zoom out
Zoom in
Previous page
1/38
Next page
25
9-3. COMPONENT TEST PROCEDURE
High voltage is present at the high voltage terminal of the high voltage
transformer during any cooking cycle.
It is neither necessary nor advisable to attempt measurement of the high voltage.
Before touching any oven components or wiring, always unplug the oven from its
power source and discharge the capacitor.
1. High voltage transformer
(A) Remove connections from the transformer terminals and check continuity.
(B) Normal readings should be as follows :
Secondary winding ... Approx. 100 ±10%
Filament winding ... Approx. 0
Primary winding ... Approx. 1.2
2. High voltage capacitor
(A) Check continuity of capacitor with meter on the highest OHM scale.
(B) A normal capacitor will show continuity for a short time, and then indicate
10MW once the capacitor charged.
(C) A shorted capacitor will show continuous continuity.
(D) An open capacitor will show constant 10M
(E) Resistance between each terminal and chassis should be infinite.
3. High voltage diode
(A) Isolate the diode from the circuit by disconnecting the leads.
(B) With the ohmmeter set on the highest resistance scale measure the resistance
across the diode terminals. Reverse the meter leads and again observe the
resistance reading. Meter with 500V dc or higher voltage batteries should be used
to check the front-back resistance of the diode, otherwise an infinite resistance
may be read in both directions. A normal diode's resistance will be infinite in one
direction and several hundred k in the other direction.
4. Magnetron
For complete magnetron diagnosis, refer to Measurement of the Microwave Output
Power." Continuity checks can only indicate and open filament or a shorted
magnetron. To diagnose for an open filament or a shorted magnetron,
(A)
Isolate magnetron from the circuit by disconnecting the leads.
(B) A continuity check across magnetron filament terminals should indicate 0.1 or
less.
(C) A continuity check between each filament terminal and magnetron case should
read open.
5. Fuse
If the fuse in the primary and monitor switch circuit is blown when the door is opened,
check the primary and monitor switch before replacing the blown fuse. In case the
fuse is blown by an improper switch operation, replace the defective switch and fuse
at the same time. Replace just the fuse if the switches operate normal
ly.
26


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Daewoo KOC 1 B4KA at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Daewoo KOC 1 B4KA in the language / languages: English as an attachment in your email.

The manual is 1,33 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Daewoo KOC 1 B4KA

Daewoo KOC 1 B4KA User Manual - English - 40 pages

Daewoo KOC 1 B4KA User Manual - English - 33 pages

Daewoo KOC 1 B4KA User Manual - Dutch - 31 pages

Daewoo KOC 1 B4KA User Manual - French - 32 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info