642868
5
Zoom out
Zoom in
Previous page
1/23
Next page
5
INSTALLATION INSTRUCTIONS
Removing transit bolts
1. Before operating the washer, remove the transit
bolts(3ea) along with the rubber.
If the bolts are not removed, it may cause heavy
vibration, noise and malfunction.
2. Unscrew the 3 bolts with the 10mm hex wrench or
spanner or cross-tip screwdriver. Keep the 3 bolts
for a later time.
When the appliance is transported, transit bolts
will be re-used.
3. Close the holes with sticker holders supplied.
Location of washer
Check location where the washer will be installed. Make sure you have everything necessary for correct
installation.
Do not place or store your washer below 0°C (32°F) to avoid any damage from freezing.
Do not place or store laundry products on top of washer at any times.
Install the washer on the horizontal solid floor.
If the washer is installed on an unsuitable floor, it could make considerable noise,
vibrate severely and cause a malfunction. If the washer is not level, adjust leg up
or down for horizontal installation.
Ventilation openings must not be obstructed by carpeting when the washer is
installed on a carpeted floor.
Leave some space (right & left : 2cm, rear : 10cm).
In case of built-in installation, the distance between top of the washer and bottom
of upper plate should be at least 3mm.
Inlet hose connection
The washer should be connected to the water mains using new hose set and old hose sets should not be
reused.
In case of only one water inlet valve, connect the inlet hose to the cold water tap.
Periodically check the tightness of the inlet hose.
Make sure that the inlet hose is not kinked or folded and that it is not crushed.
1. Connect the inlet hose
to the water tap tightly.
2. Connect the inlet
hose to the water
inlet valve tightly.
Washer
approx.
2cm
Drain Hose
Laundry
Tub
DWD-NP122'S(영)_CUTA.indd 5 15. 3. 5. 오후 5:19
5


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Daewoo DWD-NP1222 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Daewoo DWD-NP1222 in the language / languages: English as an attachment in your email.

The manual is 1,85 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info