6
INSTALLATION
FOR ORDINARY TAP
6 Connect the inlet hose
adapter of the hose to the
water inlet of the washer by
turning it clockwise to be fixed
tightly.
• Please check the rubber pack-
ing present inside the inlet hose
adapter of the hose.
1 Pull down the collar
of the inlet hose to
separate it from the
water tap adapter.
2 Loosen the four
screws properly in
order to fit into
water tap.
4 Remove the tape,
and screw connector
B into connect A
tightly.
5 Conect the inlet hose
to the water tap
adapter by pulling
down the collar of the
hose end.
3 Fit the water tap adapter into
the water tap and tighten the
four screws evenly while push-
ing up the adapter so that the
rubber packing can stick to the
water tap tightly.
■ Connecting inlet hose
In using only one water tap or in case of only one water inlet valve, connect the inlet hose to the cold water inlet valve.
Option : Be careful not to confuse hot water inlet and cold water inlet.
FOR SCREW-SHAPED TAP
3
Connect the inlet hose adapter
to the water inlet of the washer
and turn it to be fixed.
• Check the packing in the inlet.
1 Conect the inlet hose
to the water tap
adapter by pulling
down the collar of the
hose end.
2
Conect the connector-
inlet supplied if
necessary.
