10
Adjusting Method
2) Connect I2C line of the auto alignment system with housing (P503) at the top of a
convergence board.
3) Select CONV.EXE in the auto alignment system program and press ENTER.
4) Control the user convergence with a remote control after the control is finished.
b. Control of 1080i convergence
1) Repeat the above 1) to 4) for 1080i mode.
Step 8. Control of white balance
1) Connect a control pattern (intra-office signal cable broadcasting 32 CH) with external input 3.
2) Select the screen mode as standard.
3) Locate the sensor of 3298 system at the center of High/Low Beam.
4) Execute the projection program of control PC.
5) When OSD of ‘OK’ appears on the monitor of control PC, the control is completed.
Measuring unit: Multimedia Display Tester 3298(YOKOGAYA)
Measuring signal: White -Balance Control Pattern (Intra-office signal cable broadcasting
32CH)
Coordinates setup:x=0.275 0.005 / y=0.275 0.005
Initial data (S8)
R DRV : 31 (RED DRIVE)
G DRV : 40 (GREEN DRIVE)
B DRV : 31 (BLUE DRIVE)
R CUT : 61 (RED BIAS)
G CUT : 64 (GREEN BIAS)
B CUT : 61 (BLUE BIAS)
Applied chassis and model:SJ-111, 112/DSJ-5510(20),DSJ-4710(20)
