133662
19
Zoom out
Zoom in
Previous page
1/31
Next page
OPERATION
18
1. Insert the attached
AC plug into a 2-
pronged 220V~ 240V
AC outlet.
Plug into 220V AC Outlet
AC Outlet
and Plug
NOTES:
Never connect the AC line cord plug to other than the speci-
fied voltage (220V~240V).
• Use the attached power cord only.
If the outlet is a 3-pronged type or other, have an electrician
install a new outlet.
The new air conditioner system should be on it’s own 220V
circuit. Contact your local electrical installer for installation.
CONNECTING THE AC CORD
The outdoor unit is connected to the indoor unit through the AC connecting wire or connection cord. To connect the
indoor unit to AC, follow the procedures below:
BATTERY PRECAUTIONS
The precautions below should be followed when using batteries in this device:
1. Use only the size and type of batteries specified.
2. Be sure to follow the correct polarity when installing the batteries as indicated in the battery compartment.
Reversed batteries may cause damage to the device.
3. Do not mix different types of batteries together (e.g. Alkaline and Carbon-zinc) or old batteries with fresh ones.
4. If the device is not to be used for a long period of time, remove the batteries to prevent damage or injury from pos-
sible battery leakage.
5. Do not try to recharge batteries not intended to be recharged; they can overheat and rupture. (Follow battery manu-
facturer’s directions).
HOW TO INSTALL BATTERIES
To install the batteries, follow the procedures below:
Plug into 220V~240V AC Outlet.
1. Slide down the cover to access
most of the remote buttons.
Slide down further to access the
battery compartment.
2. Insert two “AAA” size
Alkaline batteries following
the polarity diagram below.
S
ON/OFF
TIMER
ENTER/
CANCEL
TURBO/MILD
+
+
1. Open the indoor unit’s cover and make sure the EMER-
GENCY/REMOTE switch
is set to the REMOTE
position; this will allow the
unit to operate with the
remote controller.
TEST/EMERGENCY/REMOTE Switch
2. Press the ON/OFF button on the remote controller to turn
on the unit. The On LED will light on the indoor unit and
“ON” will light in the remote display.
To select the various modes and
settings, read the following pages.
SETTING THE UNIT FOR REMOTE OPERATION
After the unit is fully connected and plugged in, it can be turned on. To turn the unit on and set it for remote operation,
follow the procedures below:
THREE MINUTE COMPRESSOR DELAY
After turning the indoor unit on and setting it for air condi-
tioner operation, the compressor (outdoor unit) will not
come on for three minutes. This is a feature that will protect
the compressor from damage due to quick start and stops.
EMERGENCY
REMOTE
EMERGENCY/REMOTE Switch
19


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Daewoo dsb 181 lh at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Daewoo dsb 181 lh in the language / languages: English as an attachment in your email.

The manual is 0,74 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info