CHAPTER
2
9
Chapter 2 : Connecting an Antenna or Cable to Your TV/VCR Combination
Connecting an Antenna or Cable to Your TV/VCR Combination
Your TV/VCR Combination will provide you with the best performance if you connect it to
an external antenna or cable system. Follow the directions below to make this connection.
Please note that you will normally only have to make one of the connections shown below,
not all of them.
All connections will be made to the antenna terminal on the back of your TV/VCR
Combination. The antenna terminal is a silver metal post partially surrounded by two plastic
tabs. For help in locating the antenna terminal, see “Your TV/VCR Combination's Back
Panel” on page 5.
There is no antenna provided with your TV/VCR Combination.
Connecting an Antenna
If your antenna ends in a single coaxial lead,
simply press or screw the cable onto the antenna
terminal on the back of your TV/VCR
Combination.
If your antenna ends in a pair of 300 ohm twin leads, you must use a 300-ohm/75-ohm
adaptor. (An adaptor is included with your 13” TV/VCR Combination.) Place the leads under-
neath the screws on the adaptor, tighten the screws, then press the adaptor onto the antenna
terminal on the back of the TV/VCR Combination Combination.