690883
8
Zoom out
Zoom in
Previous page
1/35
Next page
Installation
Installing the Leg Support Plate
(Optional on CGC Series Models)
For ease of installation, the brewer may be laid on its
side to allow access to the bottom. Lay the unit on a soft
padded surface to avoid scratches.
1 Remove the four legs from the bottom of the brewer
by unscrewing them. The front legs are different
from the rear legs. Note the location and difference
between the two types during removal.
2 Place the leg support plate on the bottom of the unit.
Line up the leg holes in the plate with the leg holes on
the bottom of the unit.
3 Reinstall the legs in the same positions they were
removed from in step 1.
Leveling
4 Position the unit on the countertop. Level it left to right
and front to back by turning the bottom of the legs.
Models CGC/CGC1: Setting the Brewer for 220-240
Volt Operation (Does not apply to CGCE/CGC1E)
5 Remove the screws that hold the back cover in place
and remove the cover.
6 Loosen the strain relief on the back of the brewer.
7 Disconnect the existing 120 Volt power cable from the
terminal block and remove.
8 Disconnect and cap the jumper wire between the “C”
and “N” terminals on the terminal block.
INSTALLATION INSTRUCTIONS II13
CGC, INSTALLATION INSTRUCTIONS 073119B
WARNING: Use the leveling legs to level the
brewer only. Do not use them to adjust brewer
height. Do not extend them higher than necessary.
WARNING - EXCESSIVE WEIGHT: When lifting
the brewer, at least two persons are required to
avoid personal injury.
WARNING: The water tank must be empty before
laying the brewer on its side.
Terminal
block
Strain
relief
Back of brewer with
cover removed
8


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Curtis G4 CGC Series at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Curtis G4 CGC Series in the language / languages: English as an attachment in your email.

The manual is 3,63 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info