690882
7
Zoom out
Zoom in
Previous page
1/34
Next page
Installation
Leveling
1 Position the brewer on the counter top. Level it left to
right and front to back by turning the bottom of the
legs.
Connecting the Brewer Wiring on Brewers Operated
with a 220 Volt (nominal) power supply.
2 Remove the screws that hold the back cover in place
and remove the cover.
3 Loosen the strain relief on the back of the brewer.
4 On dual voltage units being operated at 220 Volts
disconnect the existing power cable from the terminal
block and remove. Disconnect and cap the jumper
wire between the “C” and “N” terminals on the
terminal block.
5 Feed the 220 Volt power cable into the brewer.
6 Connect the wires on the power cable to the terminal
block inside the brewer.
7 Tighten the strain relief and replace the back cover.
8 Connect the power cable wires to the terminals in
the junction box. See the ELECTRICAL SCHEMATIC
for the power supply requirements. Keep the power
supply to the brewer off until the water supply line is
connected.
INSTALLATION INSTRUCTIONS II17
BREWERS, REAR COVER, INSTALLATION INSTRUCTIONS 052119B
WARNING: Use the leveling legs to level the
brewer only. Do not use them to adjust brewer
height. Do not extend them higher than necessary.
&RQ¿JXUDWLRQ
YDULHV
WARNING: Turn off power to the junction box at
the circuit breaker panel before connecting the
power cable to the brewer. Lock out and tag the
circuit breaker.
7HUPLQDO
EORFN
6WUDLQ
UHOLHI
%DFN
SDQHO
7


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Curtis G3 Series Alpha FreshTrac Decanter at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Curtis G3 Series Alpha FreshTrac Decanter in the language / languages: English as an attachment in your email.

The manual is 3,51 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info