817300
318
Zoom out
Zoom in
Previous page
1/404
Next page
316
Miscellaneous situations
1.
NOTICE
Damaged or dirty windscreen wipers could
scratch the glass.
If products containing solvents, rough
sponges or sharp objects are used to clean
the blades, the graphite layer will be dam-
aged.
Never use fuel, nail varnish remover, paint
thinner or similar products to clean the win-
dows.
In icy conditions, always check that the
wiper blades are not frozen to the glass be-
fore using the wipers. In cold weather, it may
help to leave the vehicle parked with the wip-
ers in service position ›››page314.
NOTICE
To prevent damage to the bonnet and the
wiper arms, only leave them in the service
position.
Before driving, always lower the wiper
arms.
Jump start
Introduction
If the engine fails to start because of a dis-
charged 12-volt battery, the battery can be
connected to the battery of another vehicle to
start the engine.
Jump leads complying with the DIN 72553
standard are needed for starting (see cable
manufacturer's instructions). The wire cross
section must be at least 25 mm2 for petrol en-
gines and at least 35 mm2 for diesel engines.
NOTICE
To avoid considerable damage to the vehi-
cle electrical system, note the following care-
fully:
If the jump leads are connected incor-
rectly, a short circuit may occur.
Use only jump leads with fully insulated
clamps.
Do not allow the vehicles to come into con-
tact with each other, otherwise current may
start to ow as soon as the positive poles are
connected.
Jump start: description
Fig.208 Wiring diagram for vehicles with a
start/stop system.
The discharged battery must be properly con-
nected to the on-board network.
Make sure that the clamps have suicient
metal contact when connecting them to the
poles.
Jump lead terminal connections
The jump leads should only be connected in
the order 1 > 2 > 3 > 4 ›››Fig.208.
Switch o the ignition of both vehicles
››› .
318


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Cupra Formentor 2024 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Cupra Formentor 2024 in the language / languages: English as an attachment in your email.

The manual is 17.66 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Cupra Formentor 2024

Cupra Formentor 2024 User Manual - Dutch - 430 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info