810365

Cupra Formentor - 2021 Manual

101
Zoom out
Zoom in
Previous page
1/391
Next page
Opening and closing
●Keyless Exit: locking the vehicle using the
sensor of the driver or passenger door han-
dle.
●Easy Open: opening the rear lid moving
one foot below the rear bumper
››› page 109.
●Press & Drive: keyless starting of the engine
with the starter button
››› page 207 .
The central locking and locking systems op-
erate in the same way as a normal locking
and unlocking system. Only the controls
change.
Unlocking the vehicle is confirmed with a
double flash of the indicator lights; locking
by a single flash.
If the vehicle is locked and then all doors and
the rear lid are closed leaving the last key
used inside the vehicle and none outside,
the vehicle will not lock immediately. All the
vehicle's indicator lights will flash four times.
The vehicle will lock after a few seconds if
you do not open any door or the rear lid.
The vehicle will lock again after a few sec-
onds if you unlock the vehicle but fail to
open any door or boot hatch.
Unlocking and opening the doors
(Keyless-Entry)
●Grip one of the front door handles. When
you do this, you touch the sensor surface
››› Fig. 78 A (arrow) of the handle and the
vehicle unlocks.
●Open the door.
On vehicles with selective opening or info-
tainment system configuration, pulling the
door handle twice will unlock all doors.
In vehicles without the “Safe” security sys-
tem: closing and locking the doors
(Keyless-Exit)
●Switch the ignition off.
●Close the driver's door.
●Touch (once) the locking sensor surface
››› Fig. 78 B (arrow) on one of the front door
handles. The door that is used must be
closed.
In vehicles with the “Safe” security system:
closing and locking the doors (Keyless-
Exit)
●Switch the ignition off.
●Close the driver's door.
●Touch (once) the sensor surface
››› Fig. 78
B (arrow) on one of the front door handles.
The vehicle locks with the “Safe” security
system
››› page 101 . The door that is used
must be closed.
●Touch (twice) the sensor surface
››› Fig. 78
B (arrow) of one of the front door handles
to lock the vehicle without activating the
“Safelock” security system
››› page 101 .
Unlocking and locking the boot hatch
When the vehicle is locked, the rear lid auto-
matically unlocks on opening if there is a val-
id vehicle key in the proximity zone
››› Fig. 77.
Open or close the rear lid normally.
After closing, the hatch locks automatically.
If the complete vehicle is unlocked, the rear
lid will not lock automatically after closing it.
What happens when locking the vehicle
with a second key
If there is a vehicle key inside the vehicle and
it is locked from the outside with a second
vehicle key, the key inside the vehicle is
blocked for engine ignition
››› page 207 . In
order to enable engine ignition, press the
button on the key inside the vehicle.
Automatically disabling sensors
If the vehicle is not locked or unlocked for a
long period of time, the proximity sensors on
the passenger doors are automatically disa-
bled.
If one of the sensor surfaces on the door
handles is often activated in an unusual man-
ner with the vehicle locked (e.g. by the
branches of a bush rubbing against it), all
proximity sensors are disabled for a certain
period of time.
Sensors will again be enabled: »
99
… 101 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Cupra Formentor - 2021 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Cupra Formentor - 2021 in the language / languages: English as an attachment in your email.

The manual is 13.89 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Cupra Formentor - 2021

Cupra Formentor - 2021 User Manual - German - 415 pages

Cupra Formentor - 2021 User Manual - French - 432 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info