817289
273
Zoom out
Zoom in
Previous page
1/352
Next page
Help with parking and manoeuvring
Manoeuvre braking function*
The emergency braking function is used to
minimise damage in the event of a collision.
Depending on the equipment, if the Parking
Aid is active, the braking while manoeuvring
function activates emergency braking when
it detects an obstacle in the vehicle’s path
that could cause a collision, driving forwards
or in reverse.
The function will not brake if the Parking Aid
is activated automatically. For the system to
operate, manoeuvring speed must be be-
tween 2.5-7 km/h (1.5-4 mph) for the front
area and between 1.5-7 km/h (1-4 mph) for
the rear.
Following an intervention, the braking while
manoeuvring function will be inactive in the
same direction of travel for 5 metres. Once
the gear is changed, or the selector lever’s
position is changed, the function will be ac-
tive again. The Parking Aid’s limitations ap-
ply.
The braking while manoeuvring function is
set in the Infotainment system: function but-
ton > Driver assistance> Parking aid.
Temporary suppression of emergency
braking
When the function is deactivated with the
Braking while manoeuvring button that ap-
pears on the Parking aid screen of the Info-
tainment system.
Whenever any of the car doors, rear lid or
bonnet are opened.
Rear parking aid*
Description
The rear parking aid is an optical and audi-
ble assistant that warns of obstacles located
behind the vehicle.
There are sensors integrated in the rear
bumper. When they detect an obstacle, you
are alerted by audible and visible warnings on
the Infotainment system.
Make particularly sure that the sensors are
not covered by adhesives, residues, dirt and
the like, as this could affect the system's op-
eration. Cleaning instructions
page 317 .
The approximate measurement range of the
rear sensors is:
Side area: 0.60 m
Central area: 1.60 m
As you approach the obstacle, the frequency
of the audible signals will increase. The signal
will sound continuously at around 0.30 m:
Stop! in Introduction on page 267,
in Introduction on page 267!
If the separation is maintained, the warning
volume is reduced after about 2.5 seconds.
Parking Aid connection
Select reverse gear.
Parking Aid disconnection
Drive forward at 15 km/h (9 mph) or faster.
OR: move the selector lever to position P,
N or D.
Setting the indications and audio signals
The indications and acoustic signals are set
in the Infotainment system: function button
> Driver assistance> Parking aid.
Setup
Rear volume* Volume in the rear area.
Adjust volume
When the parking aid is
switched on, the volume of
the audio source will be re-
duced, depending on the se-
lected option.
Error messages
If a an error or fault message appears on the
instrument panel in Parking assist, there is a
fault.
If the fault doesn't disappear before discon-
necting the ignition, it will not be indicated
next time the parking aid is connected. »
271
273


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Cupra Formentor - 2020 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Cupra Formentor - 2020 in the language / languages: English as an attachment in your email.

The manual is 5.27 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Cupra Formentor - 2020

Cupra Formentor - 2020 User Manual - German - 376 pages

Cupra Formentor - 2020 User Manual - French - 384 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info