810370
107
Zoom out
Zoom in
Previous page
1/357
Next page
Visibility
105
Mirrors
0
1
A
Rain sensor o.
Rain sensor on; automatic wipe if neces-
sary.
Setting sensitivity level of rain sensor:
– Set control to the right: high sensitivity.
– Set control to the left: low sensitivity.
When the ignition is switched o and then
back on, the rain sensor stays on and starts
operating again when the windscreen wipers
are in position ›››Fig.82 1 and the vehicle is
travelling at more than 16km/h (10mph).
Abnormal operation of the rain and light
sensor
The possible causes of anomalies and errone-
ous interpretations in the sensitive surface area
›››Fig.83 of the rain sensor are, among oth-
ers:
Damaged wipers: a lm of water on the
damaged blades may lengthen the activation
time, reduce the washing intervals or result in a
fast and continuous wipe.
Insects: the impact of insects may cause the
wiper to activate.
Salt on the road: in winter, salt spread on
the roads may cause an excessively long wipe
when the windscreen is almost dry.
Dirt: dry dust, wax, coating on glass (Lotus
eect) or traces of detergent (car wash) may
reduce the eectiveness of the rain sensor or
make it react more slowly, later or not at all.
Regularly clean the sensitive surface of the rain
sensor ›››Fig.83 (arrow) and check for possi-
ble damage to the wiper blades.
Windscreen crack: the impact of a stone will
trigger a single wipe cycle with the rain sen-
sor on. Next the rain sensor detects the reduc-
tion in the sensitive surface area and adapts
accordingly. The behaviour of the sensor will
vary with the size of the damage caused by the
stone.
WARNING
The rain sensor may not detect enough rain
to switch on the wipers.
If necessary, switch on the wipers manually
when water on the windscreen obstructs visi-
bility.
Note
To remove wax and coatings, we recom-
mend a window cleaner containing alcohol.
Do not put stickers on the windscreen in
front of the rain sensor. This may cause sen-
sor disruption or faults.
Mirrors
General safety instructions
The exterior and interior mirrors allow the
driver to observe vehicles driving behind and
adapt his or her driving behaviour accordingly.
For safe driving, it is important for the driver to
adjust the exterior mirrors and interior mirror
correctly before setting o.
When looking through the exterior mirrors and
the interior mirror, it is not possible to see the
entire area behind and to the sides of the vehi-
cle. These areas outside the eld of view are
known as the blind spot. Other road users and
objects may be in the blind spot.
WARNING
Adjusting the exterior mirrors and interior
mirror while driving can distract the driver.
This could cause accidents and lead to seri-
ous injuries
Only adjust the exterior mirrors and inte-
rior mirror when the vehicle is stationary.
When parking, changing lanes, overtaking
or turning, always keep a close eye on your
surroundings, as other road users or objects
may also be in the blind spot.
Always make sure that the mirrors are ad-
justed correctly and that visibility to the rear
is not reduced by ice, snow, fogging or other
objects.
107


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Cupra Ateca - 2022 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Cupra Ateca - 2022 in the language / languages: English as an attachment in your email.

The manual is 7.2 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Cupra Ateca - 2022

Cupra Ateca - 2022 User Manual - German - 383 pages

Cupra Ateca - 2022 User Manual - French - 390 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info