498284
5
Zoom out
Zoom in
Previous page
1/28
Next page
4
ASSEMBLY
INSTRUCTIONS
Read all instructions before you start.
Check that your household voltage
matches that shown on label on bottom
of food processor base.
Blade Operation
1. Put base on counter or table near electrical
outlet. Do not plug in until food processor is
totally assembled. Pick up empty work bowl,
holding it in both hands, with handle toward
you. Put bowl on base, fitting center tube
over shaft on base and placing handle
slightly to left of front center (7 o’clock).
2. Turn bowl counterclockwise as far as it will
go. It will click into locked position.
3. Pick up metal blade by center plastic part.
Never touch metal cutting blades, which are
razor sharp. Note D-shaped outline on top;
it matches shape of motor shaft.
4. Place blade over motor shaft, lining up
D-shaped outline with shape of shaft.
Blade should drop onto shaft. If it doesn’t,
twist it gently clockwise until it does. Push
top of center plastic part to push blade
down as far as it will go. Lower blade
should almost touch bottom of bowl.
5. Put cover on bowl, with feed tube at front,
slightly to left of front center.
6. Turn cover counterclockwise to lock it into
place. It will click into position. Motor will
not start unless work bowl is securely locked
in position and cover is securely locked on
work bowl.
7. Insert pusher in feed tube. Always use
pusher to guide food through feed tube.
Never use your fingers or spatula.
8. Plug your Cuisinart
®
Food Processor into
a household electrical outlet.
Disc Operation
1. Assemble bowl on base in usual way (see
steps 1 and 2 above.)
2. Always handle slicing or shredding disc by
rims. Never touch sharp cutting blades. Note
D-shaped cutout on top of disc. It matches
shape of motor shaft.
Place disc over motor shaft, lining up
D-shaped cutout over shaft. Disc will
drop onto shaft.
3. Be sure disc is pushed down as far as it will
go. Push only on rim; never touch sharp
cutting blade.
4. Put cover on work bowl and turn it
counterclockwise to lock it into place.
5. Put food into feed tube. (If you are slicing,
first cut one end of food flat.)
6. Insert pusher. Use moderate pressure to
push down on pusher with one hand while
holding control switch down with other hand
until food is sliced or shredded. This will take
only a few seconds.
Never put fingers or spatula in feed tube.
Always use pusher.
Wait until disc stops spinning before removing
cover. When it stops, remove cover before
removing work bowl. Never try to remove cover
and work bowl together; this could damage
work bowl.
Remove disc before removing work bowl. Place
two fingers under each side of disc and lift it
straight up.
Then turn bowl clockwise to remove it from
base and lift it straight up.
OPERATING CONTROLS
Control switch on base of machine has 3 posi-
tions, giving you fingertip control of operation.
For continuous operation, move control switch
up to ON position. Motor will start.
To turn motor off, move control switch down to
OFF position in center.
For on-off operation, called pulse-chopping or
pulsing, press control switch down to PULSE
position, then release it.
Motor runs as long as you hold control switch
down. Motor stops when you release control
switch. Try it a few times.
Notice that you control duration and frequency
of pulses by length of time you hold control
switch down and rate at which you press it.
Allow enough time between pulses to let
everything in work bowl fall to bottom.
Always use control switch for pulse/chopping.
Never turn cover back and forth to start and
stop processor.
03CU13009 DLC-5 IB REV vert 6/23/03 1:55 PM Page 5
5


Need help? Post your question in this forum.

Forumrules
1

Forum

cuisinart-dlc-5

Reset search

  • Geachte heer mevr,

    Wij hebben een Cuisinart DLC 10 keukenmachine en willen graag een handleiding in het Nederlands hebben.
    We kunnen alleen de handleiding in het Engels vinden op de site.

    Graag u reactie, bij voorbaat dank,

    Met vriendelijke groeten,

    Ine v.d Westelaken.
    Lorentzstraat 18
    5707EW Helmond
    Noord Brabant
    Nederland
    E-mailadres inewestelaken@gmail.com


    Submitted on 30-12-2020 at 16:38

    Reply Report abuse


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Cuisinart DLC-5 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Cuisinart DLC-5 in the language / languages: English as an attachment in your email.

The manual is 1 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info