Case Check points Do the following
When the rice is not
cooked.
When the rice is not
well cooked.
Bean (other grains)
is half cooked.
Rice is too watery or
stiff.
When the water
overflow.
When you smell
something while
warming.
Did you use the measuring cup to
measure your rice?
Did you measure water properly?
Did you wash the rice before cooking?
Did you put rice in water too long time?
Is the rice old or dry?
Is bean (other grains) too dry?
Is the selected the menu correct?
Did you measure water properly?
Did you open the lid before cooking
was finished?
Did you use the measuring cup?
Did you measure water properly?
Is the selected the menu correct?
Did you close the lid.
Please check the power cord plugged
in the outlet.
Did it warm over 12 hours?
Is there any other substance such as
rice scoop or cold rice.
Refer to page 11.
Insert some more water (about half of 1 level)
Soak or steam beans and other grains
before cooking in the pressure cooker in
order to avoid partially cooked beans or
grains. Beans should be soaked for-to-
minutes or steamed for-to-minutes prior
to cooking, depending on your taste.
Select the correct menu.
Measure the water properly.
Open the lid after cooking is
finished.
Refer to page 11.
Close the lid perfectly.
Always be keeping the power on while
warming.
Warm less then 12 hours.
Don’t warm rice with other substance.
“Pressure Cook/Turbo” button is pressed?
Is there power cut while in cooking?
Press the “Pressure Cook/Turbo” button once.
And check
sign on the display.
Re-press the “Pressure Cook/Turbo” button.
Clean all the alien substance on the
temperature sensor, heating plate or the
bottom surface of the inner pot.
Is there any rice or any other alien
substance on the temperature sensor,
heating plate or the bottom surface of
the inner pot?
When the rice is
badly sticky.
“ ”, “ ”
sign is appeared.
There is some problem on the
temperature sensor.
Please contact to dealer or service
center.
Please insert inner pot.
Please turn the Lock/Unlock Handle to
"Lock"
Is there inner pot?
Did you turn the Lock/Unlock Handle to
"Lock"
Is “lock” lamp on?
When the button
cannot operate with
“ ”
.
When the “Pressure
Cook/Turbo”, Timer
button are not operate
with “ ”
If there is a problem with your cooker, check the following details before requesting service to your
dealer. Sometimes the cooker may not operate as desired if used incorrectly.
It is the function to alarm you that warming has
gone too much, especially more than 24 hours.
Check whether warming continued for
more than 24hours?
When warm processing
time sign blinks.
Use keep warming set either ‘sleep
warming on’ or off to your need.
Have you checked if you set the
cooker on ‘sleep warming’ mode?
When the dish is not warm
enough or if there is too
much evaporation from the
rice for using “Keep warm”
