534695

Cubify CubeX Manual

30
Zoom out
Zoom in
Previous page
1/37
Next page
LEVELING THE JET WIPER HEIGHT
If your Jet Wiper is set too low or too high, you can adjust it using the orange capped
bolt located under the print jet, screwing it into the oor to set the Jet wipe lower and
unscrewing it to set the Jet Wipe higher. (Fig. 95)
It is important that the Print Pad is level in order to get a good print. To help you out,
we make every effort to ensure that the Print Pad is level when the machine leaves
our factory. However, the Print Pad may move in transit, making it necessary to
check that it is still level when it reaches you.
You will rst need to ensure that your aluminum pad support is level. After this you
can install the Print Pad and ne-tune the leveling.
NOTE: When leveling the Print Pad, always use print tip 1 as your reference.
RESTORING ROUGHNESS TO THE PRINT PAD
To restore roughness to the Print Pad, run the sandpaper included in your toolkit
diagonally across the bed corner to corner in both directions. (Fig. 94)
CUBEX MAINTENANCE
29
Fig. 94
Fig. 95
LEVELING THE PRINT PAD
Make sure the Print Pad is securely installed onto the Aluminum Print Plate. Do not perform leveling function without the
Print Pad correctly installed.
The aluminum print plate is mounted on three sprung bolts which allow you to adjust the height of the Print Plate in three
places.
The ‘Level’ function moves the extruder carriage around the corners of the print area so the operator
can adjust the Print Pad support bolts for leveling.
1. Select ‘Level’ on the touchscreen. (Fig. 96)
Fig. 96
Fig. 97
2. Use the Up and Down arrows to raise and lower the print plate to adjust the
gap between the print jet tip and Print Plate. Start with approximately 10 mm
between the tip and the Print Pad. This distance will enable rough leveling. (Fig.
97)
LEVEL
… 30 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Cubify CubeX at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Cubify CubeX in the language / languages: English as an attachment in your email.

The manual is 4,56 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info