534695

Cubify CubeX Manual

27
Zoom out
Zoom in
Previous page
1/37
Next page
REMOVING YOUR CREATION FROM THE PRINT PAD
Before you attempt to remove your creation from the Print Pad, please ensure that the CubeX has nished
printing and that the Print Pad has moved to the bottom of the CubeX.
1. Lift the Print Pad from the side and pull up to remove the Print Pad from the
CubeX.
2. Submerge Print Pad and the base of the part in warm water for ve minutes.
(Fig. 92) If you do not have the ability to submerge the Print Pad place Print Pad
in sink and let hot water run over the base of the part for about 5 minutes.
REMOVING RAFTS
A raft is the at support structure that is attached to your creation. Though we recommend printing without a raft, some larger
or more complicated parts may require one. If you print with a raft, the following instructions will help you remove it:
REMOVING SUPPORTS WITH WIRE CUTTERS
Use wire cutters to cut away the support structure from your model. You should cut the supports at the point where they
touch the model.
FINISHING YOUR CREATION
!
Fig. 92
Fig. 93
ABS RAFT / PLA PART - PLA RAFT / ABS PART ABS rafts can be peeled away from PLA parts.
ABS RAFT / ABS PART - PLA RAFT / PLA PART Use pliers to pull away as much of the raft as possible.
Then use a rough-grade sandpaper to remove the
remaining raft, followed by a ne-grade wet and dry
sandpaper to achieve a smoother nish.
26
3. Using the scraper (included in tool kit), gently release your creation from the
glass. (Fig. 93)
4. Rinse your creation under hot water to ensure all of the Magic CubeX Glue paste has been removed.
5. To clean the Print Pad, rinse the pad under hot water to clean off any remaining Magic CubeX Glue paste.
6. Dry the Print Pad thoroughly before reinstalling it into CubeX.
… 27 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Cubify CubeX at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Cubify CubeX in the language / languages: English as an attachment in your email.

The manual is 4,56 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info