657563
72
Zoom out
Zoom in
Previous page
1/75
Next page
| 63 62 |
MTB/ ROAD BIKE/ TREKKINGMTB/ ROAD BIKE/ TREKKING
There is no lever on the brake:
Follow the reverse procedure to opening
and press the pin on the brake lever from
outwards to inwards.
At the same time, pull the brake lever.
4. Check installation:
Operate the brakes.
If the brake block or brake touches the rim
or the brake disks, this can indicate that the
hub has not been correctly seated in the
dropouts.
In that case release the quick release, check
and correct the hub seat and close the quick
release again.
The brake (on rim brakes) must not be
opened during this procedure. If there is no
improvement after this, please contact your
dealer immediately.
11.2 Remove and replace seat post
and saddle
Risk of Personal Injury and
Material Damage!
An incorrectly tted saddle post can lead
to dangerous riding situations, falling,
accidents and material damage.
You must have your dealer demonstrate
tting and removing your saddle post.
Practise this job at least once under his
supervision and control.
Only remove and t the saddle post and
saddle if you are sure you have mastered
this job.
For transportation, you can remove your bike‘s
saddle post complete with saddle and replace it
again afterwards.
The saddle post is held with a clamp in the frame se-
at tube and is tightened with either a quick release
or a hexagon socket.
On carbon bre saddle posts, special types may be
tted with two screws.
For clamping without a quick release, a hexagon
socket and a torque wrench of the appropriate size
are required. Please also consult your dealer.
To remove your saddle post:
1. Release the saddle clamp at the quick
release as per Chapter 8.8 or by loosening
the Allen screw with an Allen key.
2. Withdraw the saddle with saddle post
from the frame.
To replace your saddle post:
placing the rear wheel under it so that the
chain is over the smallest sprocket
Carefully lower the rear of the bike until the
axle is at the dropout stop on the right and
left sides.
b) To assemble the front wheel
Lift up the bike by the handlebars,
placing the front wheel under the front forks
dropouts and
carefully lower the forks until the axle is ush
at the dropout stops on the right and left
sides.
2. Tighten the wheel hubs.
When tightening with quick releases: see
Chapter 8.8
3. Close rim brakes
a) On racing bike brakes:
Shimano und Sram:
Move the lever downwards.
b) Campagnolo:
72


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Cube MTB at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Cube MTB in the language / languages: German as an attachment in your email.

The manual is 8,82 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Cube MTB

Cube MTB User Manual - English - 37 pages

Cube MTB User Manual - Dutch - 37 pages

Cube MTB User Manual - French - 37 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info