648269
3
Zoom out
Zoom in
Previous page
1/8
Next page
EN • 5
EN
CHECK THE RESULT LAMPS
If the result lamp is lit:
CHECK BATTERY
CHECK START POWER
BELOW 12.4V 12.412.6V ABOVE 12.6V
BELOW 9.6V 9.610.5V ABOVE 10.5V
CHECK ALTERNATOR
BELOW13.3V 13.314.0V ABOVE 14.0V
CHARGING PROGRAMS AND OPTIONS
Press the MODE-button to select between the charging programs and to add charging
options. The lamps will indicate which programs and options that are selected. The
selected program will be memorised and restarted next time the charger is connected.
Charging Programs
Program
Battery
Size (Ah)
Explanation Temp range
1.214Ah
Small battery
program, 0.8A
Use for smaller batteries.
-2C–+5C
(-F–122ºF)
14–160Ah
Normal battery
program, 5A
Use for normal sized batteries.
-2C–+5C
(-F–122ºF)
Charging Options
Option
Battery
Size (Ah)
Explanation Temp range
1.2160Ah
Cold weather option
Use for charging at low tempera-
tures and for power AGM batteries
like Optima
®
and Odyssey
®
. Cold
weather option increases charging
voltage
-2C–+5°C
(-F–4F)
RECOND
1.2160Ah
Recond option
Use to return energy to empty
batteries. Recond your battery once
per year and after deep discharge
to maximise lifetime and capacity.
The Recond option adds STEP6
to the selected charging program.
Repeated use of the Recond
program may cause water loss in
the battery and reduce service life
of electronics. Contact your vehicle
and battery supplier for advice.
-2C–+5C
(-F–122ºF)
BAD FAIR OK
HOW TO USE: VOLTAGE CHECK PROGRAM
WITHOUT SUPPLY PLUG CONNECTED
1. Connect the charger to the battery. The battery voltage needs to be higher than 8.0V to
be able to use this setup.
2. The VOLTAGE CHECK PROGRAM is automatically selected and the three VOLTAGE
CHECK result lamps will flicker, to indicate VOLTAGE CHECK PROGRAM until a
programisselected.SelectaVOLTAGECHECKPROGRAMwithin30sekotherwise
the VOLTAGE CHECK PROGRAM will exit. The lamps in the lower row will indicate
the VOLTAGE CHECK PROGRAM selected. To select another VOLTAGE CHECK
PROGRAM, press the MODE-button briefly. The VOLTAGE CHECK result lamps will
flicker again until a result is shown:
RED: Indicates BAD
YELLOW: Indicates FAIR
GREEN: Indicates OK!
3. Exit the VOLTAGE CHECK PROGRAM at any time by pressing the MODE-button for
about 2 seconds.
4. To use the VOLTAGE CHECK PROGRAM after mains power has been turned off, one
of the leads connected to the battery has to be removed for at least 30 seconds.
3


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Ctek MXS 5.0 CHECK at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Ctek MXS 5.0 CHECK in the language / languages: English as an attachment in your email.

The manual is 2,9 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Ctek MXS 5.0 CHECK

Ctek MXS 5.0 CHECK User Manual - German - 8 pages

Ctek MXS 5.0 CHECK User Manual - Dutch - 8 pages

Ctek MXS 5.0 CHECK User Manual - French - 8 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info