648338
2
Zoom out
Zoom in
Previous page
1/8
Next page
2 • EN
INTRODUCTION
Congratulations on purchasing your new CTEK professional switch mode battery charger. This charger is part of a range of
professional battery chargers from CTEK SWEDEN AB. It represents the latest technology in battery charging with charging
and analysis in eight steps with temperature compensation. Read this User Manual and follow the instructions
carefully before using your new charger.
SAFETY
The charger is designed for charging only batteries according to the
technical specication. Do not use the charger for any other purpose.
Always follow battery manufacturers’ user and safety recommendations.
Never try to charge non-rechargeable batteries.
Never place the charger on top of the battery or cover the charger
when charging.
Never charge a frozen or damaged battery.
Never charge a Li-battery with temperature below 0°C (32°F) if not
specied by the battery manufacturer.
Never use a charger with damaged cables. Ensure that the cables have
not been damaged by hot surfaces, sharp edges or in any other way.
Never place a fan-cooled charger so that dust, dirt or similar can be
sucked into the fan.
A damaged cable must be replaced by a CTEK representative using an
original part supplied by CTEK. A detachable cable can be replaced by
the user using an original part supplied by CTEK.
Connection to the mains supply must be in accordance with the national
regulations for electrical installations.
Chargers with grounded mains plug must only be connected to a
grounded socket outlet.
During charging, Lead-Acid batteries could emit explosive gases. Pre-
vent sparks close to the battery. Provide for good ventilation.
Chargers with IP-class lower than IPx4 are designed for indoor use. See
technical specication. Do not expose to rain or snow.
Connect the charger to the battery´s positive pole and then to the neg-
ative pole. For batteries mounted inside a vehicle, connect the negative
connection to the vehicle chassis remote from the fuel pipe. Then con-
nect the charger to mains supply.
Disconnect the charger from the mains supply. Next remove the nega-
tive connection (vehicle chassis) and then the positive connection.
Don’t leave any battery unattended for a longer period of time during
charging. If any error occurs disconnect the charger manually.
• (IEC 7.12 ed.5) This appliance is not intended for use by persons
(including children) with reduced physical, sensory or mental capabili-
ties, or lack of experience and knowledge, unless they have been given
2


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Ctek M200 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Ctek M200 in the language / languages: English as an attachment in your email.

The manual is 0,21 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Ctek M200

Ctek M200 User Manual - German - 8 pages

Ctek M200 User Manual - Dutch - 8 pages

Ctek M200 User Manual - French - 8 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info