498273
14
Zoom out
Zoom in
Previous page
1/20
Next page
Connect RCA cable from
head-unit with RCA input
(LINE INPUT).
Connection for
Remote control
If you use more than one
subwoofer you can optionally
Use Channel two
Minimum impendance
not under 1 Ohm
Monoblock-Amplifier - Speaker wiring and Connection
MXB 1200i
Caution
Be careful not to connect speaker (-) to the ground or vehicle chassis.
Interconnect cable checklist:
• Connect the LINE INPUT of the amplifier to the head unit line output with good quality
RCA to RCA cables.
• Connect the speakers with the terminal block (SPEAKER OUTPUT/ - LEFT + and -
RIGHT +) of the amplifier.
•The minimum final speaker impedance must not be below 2 Ohm per channel. Too low
speaker loads result in too high heat dissipation and may cause the amplifier run into
protection.
• Please observe speaker channel and polarity as printed by the speaker terminal block.
Incorrect phasing of the speakers results in total loss of bass response.
INPUT LEVEL
• Turn the INPUT LEVEL control on the amplifier to 5V position.
• Turn the head unit volume control to about 80-90% of its full setting.
• Turn the INPUT LEVEL control clockwise until you hear some distortion.
• Then turn back the INPUT LEVEL control slightly until you can hear clean sound.
Low pass
• This eliminates the higher frequencies.Set the crossover-frequency between 50Hz-100Hz, depending of the size of the
installed speakers.
Subsonic
• This eliminates the lowest frequencies and protects the speakers from damage.
Bass EQ
Allows you to adjust the bass boost from 0dB up to 18dB
Caution! Please use the Bass-Boost carefully.
The additional boost may result in clipping or overload.
14
0 dB 18 dB
14


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Crunch MXB 5900i at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Crunch MXB 5900i in the language / languages: English, German as an attachment in your email.

The manual is 2,01 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info