498238
10
Zoom out
Zoom in
Previous page
1/12
Next page
10
CAUTION!
Please do not connect any speaker (-) to the ground or vehicle chassis.
Amplifier - Applications
Interconnect cable checklist:
• Connect the INPUT of the amplifier to the head unit line output with good quality RCA to RCA cables.
• Connect the Subwoofer with the terminal block (SPEAKER OUTPUT/ - +) of the amplifier.
•-The minimum final speaker impedance should not be lower than 1 Ohms. Too low speaker loads result in too high heat
dissipation and may cause the amplifier run into protection.
• Please observe speaker channel and polarity as printed by the speaker terminal block. Incorrect phasing of the speakers
results in total loss of bass response.
INPUT LEVEL
• Turn the INPUT LEVEL control on the amplifier to 5V position.
• Turn the head unit volume control to about 80-90% of its full setting.
• Turn the INPUT LEVEL control clockwise until you hear some distortion.
• Then turn back the INPUT LEVEL control slightly until you can hear clean sound.
LOWPASS
The lowpass filter eliminates the higher frequencies. The recommended crossover frequency ranges between 60 -
100Hz, depending on the size and response of the Subwoofer.
SUBSONIC
• The Subsonic filter sets the lower cut-off frequency and protects the Subwoofer from damage. The recommended
subsonic frequency ranges between 15 - 40Hz, depending on the size and response of the Subwoofer.
BASS BOOST
• The BASS BOOST - Control increases the bass level at 45 Hz max. +12dB.
Caution! Please use the Bass-Boost carefully. The additional boost may result in clipping or overload.
Connect the RCA cable from head-unit
or a additional multichannel-amplifier
with RCA input
Connect cable from REMOTE CONTROL
with the input jack of the amplifier.
Subwoofer 1 - 8 Ohms
The optional RCA Fullrange Outputs
(OUTPUT) forwarding the audiosignal.
0dB 18dB
REMOTE
CONTROL
You can connect a additional
subwoofer with the free speaker
outputs. But please observe the
correct speaker impedance.
10


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Crunch GTS1100 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Crunch GTS1100 in the language / languages: English, German as an attachment in your email.

The manual is 0,29 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info