67609
21
Zoom out
Zoom in
Previous page
1/28
Next page
21
4 Channel Amplifier - Applications
GTS480/GTS4125
Connect RCA outputs from
head-unit with RCA inputs
(INPUT CH1/2 and CH3/4).
One 4 Channel Amplifier with Front-/Rear Speakers
Interconnect cable checklist:
• Connect the head unit line outputs with good quality RCA to RCA cables to the INPUTCH1&2 /
CH3&4 of the amplifier.
• Connect the Front-/Rear Speakers with the terminal blocks (SPEAKERS / + CH1 -,
+ CH2 -, + CH3 -, and + CH4 -) of the amplifier.
• The minimum final speaker impedance must not be below 2 Ohm per channel. Too low
speaker loads result in too high heat dissipation and may cause the amplifier run into
protection.
• Please observe speaker channel and polarity as printed by the speaker terminal block.
Incorrect phasing of the speakers results in total loss of bass response.
FILTER SELECT (CH1/2 & CH3/4)
If larger than 20 cm speakers are used, the FLAT position is recommended.
For all smaller speakers (Ø8.7cm - Ø16cm) the Highpass-Position (HIGH PASS) is recommended, which eliminates the
lowest frequencies and protects the speakers from damage. Set the crossover-frequency between 60Hz - 150Hz,
depending of the size of the installed speakers. The Highpass adjustment can be done with the HIGH PASS control.
• In this configuration example the LOW PASS control is not used.
INPUT LEVEL (CH1/2 & CH3/4)
• Turn the INPUT LEVEL controls on the amplifier to 4V position.
• Turn the head unit volume control to about 80-90% of its full setting.
• Turn the INPUT LEVEL controls clockwise until you hear some distortion.
• Then turn back the INPUT LEVEL controls slightly until you can hear clean sound.
BASS BOOST (CH1/2 & CH3/4)
• Turn the BASS BOOST control into “0dB” - position.
INPUT SELECT
• The INPUT SELECT - switch must be in “4” - position.
Caution
Be careful not to connect speaker (-) to the ground or vehicle chassis.
L RL R
Rear-Speakers 2 - 8 Ohms
Front-Speakers 2 - 8 Ohms
Green: Left Speaker -
White: Left Speaker +
Black: Ground
Brown: Right Speaker +
Gray: Right Speaker -
HI INPUT
21


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Crunch GTS 280 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Crunch GTS 280 in the language / languages: English, German as an attachment in your email.

The manual is 1,47 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info