618021
2
Zoom out
Zoom in
Previous page
1/2
Next page
USE THIS TEMPLATE
TO DETERMINE THE POSITION OF
TELEPHONE ON WALL,
AND WHERE TO LOCATE
SCREW HOLES.
USE ONLY FOR WALL
INSTALLATION OF TELEPHONE SET
TOP
MOUNTING HOLE A
REMOVE TEMPLATE FROM
WALL BEFORE INSERTING
PLASTIC ANCHORS OR SCREWS
MOUNTING HOLE B
SET UP
DIAL MODE
The DIAL MODE switch is located at the back of the telephone. Slide the switch to TONE unless you have
Dial-Pulse (Rotary) telephone service in your area, in which case, slide the switch to the PULSE position.
MECHANICAL BELL RINGER
CONTROL
The RINGER CONTROL switch at the back of the telephone
allows you to turn the ringer ON or OFF. You can still make
or receive calls with the ringer in OFF position, however, you
will not hear the incoming ring.
RECEIVER VOLUME
The RECEIVER VOLUME CONTROL switch, located on
the bottom of the telephone, allows you to adjust the
volume of the receiver earphone from LOW and HI.
INSTALLATION
To connect the telephone, connect the line cord from the
back of the telephone to the wall jack.
MAKING AND ANSWERING CALLS
To get a dial tone or answer an incoming call, lift the handset.
To hang up, either replace the handset or press the HANDSET
CRADLE manually.
FLASH
Pressing FLASH sends the electronic equivalent of a switchhook
signal. Use FLASH with special phone company services such
as call waiting.
REDIAL
Pressing redial will call the last number dialed from this phone
IF THERE IS NO DIAL TONE
1) Make sure that all plugs are connected properly. Check
the connections at the wall jack, the telephone cabinet
and handset.
2) Try another modular jack within your home which you
know to be working properly.
IF CALLS CANNOT BE DIALED
OR DIALS SLOWLY
Check to make sure that the DIAL MODE switch is in the
correct position for the type of service (TONE/PULSE)
available in your area.
IF THE TELEPHONE DOES NOT RING
Check that RINGER CONTROL switch is not set to OFF.
If there are several telephones connected to the same line,
try disconnecting some of the other telephones. Having too
many telephones connected to the same line can cause low
ringer volume or poor sound quality during calls.
CARE AND MAINTENANCE
Avoid rough treatment to the telephone. Do not drop the
handset and always place it gently back in the cradle. Clean
only with slightly dampened cloth. Do not use detergent, wax,
solvent, spray, alcohol or excessive water.
PARTS INCLUDED
Your new telephone includes the following items:
1 - Telephone handset
1 - Handset coil cord
1 - Telephone body
1 - 7 Foot line cord
1 - 15 Inch line cord
2 -
Screws
with wall archors
1 - Wall mounting template.
4 - Rubber spacer pads.
2 - Tapping screw
1 - Template (See above picture and instructions)
2


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Crosley CR55 - 302 Wall Phone at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Crosley CR55 - 302 Wall Phone in the language / languages: English as an attachment in your email.

The manual is 0,19 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info