630403

Crosley C100 Manual

6
Zoom out
Zoom in
Previous page
1/12
Next page
1 Remove the turntable from the box and remove the packaging.
2 Put the 45-rpm adaptor into its holder.
3 Set the turntable platter onto the center spindle.
a. Once the turntable platter is in place rotate the platter so that the large window is that the top right
corner, allowing you to access the pulley on the drive motor as shown below.
b. Carefully grab the drive belt, (already attached to the underside of the turntable platter), and place it
around the pulley on the drive motor.
4 Put the slip mat over the platter.
5 Insert the headshell into the front end of the tonearm, and then turn the locknut clockwise with the headshell
firmly held horizontally.
6 Slide counterweight onto tonearm and twist it lightly onto the rear shaft of the tonearm.
7 Adjustment of horizontal “zero” balance and stylus pressure:
a. Remove the stylus protector from the headshell and avoid touching the stylus tip during the adjustment.
b. Lower the tonearm using the cue lever.
c. Using the cue level, lower the tonearm to its lowest position.
d. Rotate the counterweight towards the front of the turntable until the tonearm is balanced (floats freely).
e. Return the tonearm back to the tonearm rest.
f. Hold the counterweight stationary with one hand and rotate only the downforce scale until the “0” on
the scale lines up with the centerline marked along the top of the tone arm.
g. Rotate the counterweight including the downforce scale counter-clockwise (as seen from the front of
the turntable) until the scale shows the value corresponding to the pressure required for stylus.
NOTE: The recommended downforce for the factory fitted cartridge is 3.5g
8 Set the anti-skating control knob to the same value as the stylus pressure.
9 Install the turntable lid to the hinges.
10 Place the turntable on a flat, level surface. To help ensure the turntable is level, the height of the legs can be
adjusted by rotating them.
GETTING PREPARED
4
… 6 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Crosley C100 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Crosley C100 in the language / languages: English as an attachment in your email.

The manual is 0,52 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info