772407
23
Zoom out
Zoom in
Previous page
1/48
Next page
21
CroozerKid14-ENG-11-13
Converting the Croozer Kid to a Stroller
6. Insert the security pin (1) through both holes of the
hitch-arm attachment bracket.
7. Lock the security pin in place by snapping the wire
loop over the end of the pin.
8. Repeat steps 3 to 7 for the right wheel arm.
Always check that the wire loops of the security pins are
snapped securely onto the pin ends. If the security pins
are not securely locked, the wheel arms could fall off
while in use, resulting in accidents with serious injury or
death.
Installing the Stroller wheel
1. Open the quick-release of the Stroller wheel by lifting
the quick-release lever (6) until the lever side marked
“OPEN” is facing outwards, away from the wheel.
2. Slide the Stroller wheel (2) as far as possible into the
slots in the dropouts of the wheel arms. The  attened
surfaces (3) on the axle must be lined up with the slots
in the dropouts.
Tip: If you have difficulties sliding the Stroller wheel into
the slots in the dropouts, then loosen the tension-
adjusting nut of the quick-release by turning it a few
turns anticlockwise and try again.
3. With the quick-release lever in the open position,
tighten the tension-adjusting nut (4) by turning it clock-
wise until you feel a slight resistance.
4. Close the quick-release by moving lever (1) towards
the wheel arm until the lever side marked “CLOSE”
is facing outwards. If the tension-adjusting nut has
been tightened the proper amount, you will be able to
feel the resistance increase when the lever is about
halfway closed, i.e. parallel to the axle. The adjust-
ment is correct if you can fully close the lever but with
considerable force. In the closed position, the lever
should be parallel to the dropout (5) of the wheel arm,
i.e. it should not stick out to the side.
5. Check whether the quick-release is securely engaged
by trying to rotate the endcap of the mechanism
(where the lever is attached) without opening the lever.
If the endcap is loose enough to rotate, then the
clamping force is inadequate. In this case, open the
lever, and tighten the tension-adjusting nut (4) half a
turn clockwise. Repeat steps 4 and 5.
If it is impossible to push the quick-release lever (1)
into the closed position, then open the lever, and
unscrew the tension-adjusting nut half a turn anticlock-
wise. Repeat steps 4 and 5.
ClosedOpen
1
44
45
46
2
6
2
1
3
47
6
4
5
48
23


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Croozer Kid 2014 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Croozer Kid 2014 in the language / languages: English as an attachment in your email.

The manual is 2.13 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Croozer Kid 2014

Croozer Kid 2014 User Manual - German - 48 pages

Croozer Kid 2014 User Manual - Dutch - 48 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info