29
4. Jogger Set
4.1. Assembling the Jogger Set
4.1.1. Fitting the Wheel Arms
Put both wheel arms on the correct side of the carrier as shown in the
picture.
Follow the same procedure for inserting and locking the wheel arms as for
the drawbar.
4.1.2. Fitting the Front Wheel
Open the quick release lever as far as
possible. It may be necessary to loosen
the adjusting nut of the quick release by
a few turns so that the latter can be
pushed into the dropouts.
Insert the wheel axle into the dropouts
of the wheel arms and centrally align the
wheel.
Tighten the adjusting nut of the opened
quick release clockwise until the
supporting surfaces of the quick release
are up against the dropout.
Close the quick release. The quick release is properly adjusted
when you can clearly feel resistance as
you tighten. You should feel this
resistance about 60° before the final
point in the lever movement.
Please note: If the quick release is
tightened too much, the plastic
dropouts can be damaged and so
impair proper functioning.
Tip: Any deviation of the jogger from
a straight line when in use can be
corrected by further alignment of the
front wheel.