Please take special care in reading this page!
Please note that thread may break, stitches
may be skipped and fabric may be puckered,
when these steps are not followed in the
right order.
Before threading, raise the needle to its highest
position by turning the balance wheel (28) and
by lifting the presser foot lever (23).
Place a spool of thread onto a spool holder (31),
as shown, so that the thread will be led from the
backside of the spool. Hold the spool with your
right hand.
1. Now lead the thread under the spring clamp
through the upper thread guide (22),
as shown.
2. Then lead the thread between the tension
disks of the upper thread tension dial (20),
as shown.
Threading of the upper thread
16
1
2
Tension disks
Thread take-up lever
Spring clamp
Upper thread guide
Note:
For normal operation the upper thread
tension dial should be set to 3.
