736569
9
Zoom out
Zoom in
Previous page
1/47
Next page
9 GB/IE
Safety instructions / Assembly
Battery Safety
Instructions
WARNING!
DANGER TO LIFE! Keep
batteries out of the reach of children. Do not
leave batteries lying around. There is a risk of
children or animals swallowing them. Consult a
doctor immediately if a battery is swallowed.
J
EXPLOSION HAZARD! Never
recharge nonrechargeable batteries,
short-circuit and / or open batteries.
This can cause them to overheat, burn or burst.
Never throw batteries into fire or water. The
batteries may explode.
J Immediately remove a spent battery from the
appliance. There is an increased risk of leakage
otherwise!
J Check the battery regularly for leaks.
J Leaked or damaged batteries can cause chemical
burns if they come into contact with the skin; in
such cases you must wear suitable protective
gloves.
J Remove the battery from the product if it is not
going to be used for a prolonged period.
J Make sure that the polarity is correct when you
insert the battery. This is indicated in the battery
compartment.
J Remove any used battery from the device. Very
old or used batteries may leak. The chemical
liquid will damage the product.
J Do not dispose of batteries in the domestic waste!
J All consumers are required by law to dispose
of batteries properly!
J Avoid contact with the skin, eyes and mucous
membranes. In the case of contact with battery
acid, rinse the affected area with plenty of water
and / or consult a doctor!
J Use only batteries of the specified type (see
“Technical Data”).
Q
Assembly
J Make sure the product is only assembled by
competent person.
The swing stepper comes, for the most part, preas-
sembled. The few assembly steps that have to be
taken are described below. You will need to use
the crosshead (Philips) screwdriver supplied.
Figure A:
j Insert the two plastic feet
3
into the back frame
pipe
2
in such a way that the supporting sur-
face of the plastic feet
3
point backwards.
Screw the self-tapping screw
9
into each of
the pre-drilled holes in the lower side of the
frame pipe
2
.
Figure B:
j Turn the adjusting screw
7
into the screw
thread on the front frame of the swing stepper.
Note: You can adjust the step height by means
of the adjusting screw
7
. Turning it clockwise
will raise the platforms
1
; turning it anticlock-
wise
will lower the platforms
1
and thus
decrease the step height.
Figure C:
j Pull the computer
8
upwards so that it comes
off the casing. Insert the battery included in
delivery into the battery compartment on the
lower side of the computer
8
. Ensure correct
polarity.
Ensure that the plug
10
is correctly plugged in.
Insert the computer
8
back into the casing
again. To do so, press gently on the projection
11
.
Make sure that the cable does not bend or jam.
Figure D:
j Select the desired elastic cords
5
. Three differ-
ent strengths are supplied for various loads.
See also the table under “Getting started”.
j Now attach the elastic cords
5
. Attach the
two elastic cords
5
by means of snap hooks
14
in the respective eyelet
4
. Before every
training session please ensure that the elastic
cords
5
are securely attached.
The swing stepper is now ready for use.
m ATTENTION! The eyelets
4
must not be sub-
jected to transverse loads as they are only designed
9


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Crivit Z29550 IAN 53313 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Crivit Z29550 IAN 53313 in the language / languages: English, Danish as an attachment in your email.

The manual is 1,74 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Crivit Z29550 IAN 53313

Crivit Z29550 IAN 53313 User Manual - German, Dutch, French, Italian - 40 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info