779282

Crivit QUADROCOPTER - IAN 322151 Manual

19
Zoom out
Zoom in
Previous page
1/54
Next page
21GB/IE
Possible errors
Potential errors are listed below, along with their causes and how to rectify them.
Error Possible cause Remedy
Remote control (2) does
not respond.
Remote control (2) is switched off. Turn on remote control (2).
Batteries (5) incorrectly inserted. Insert the batteries (5) correctly.
Batteries (5) are dead. Replace the batteries (5).
The quadcopter (1) does
not respond.
The batteries (5) in the remote control
(2) were incorrectly inserted or are
dead.
Check the batteries (5) and replace if necessary.
The rechargeable battery (9) in the
quadcopter (1) is flat.
Charge the rechargeable battery (9).
The control lights (1h) do not flash or
do not light up.
Charge the rechargeable battery (9).
The quadcopter (1) is out of range. Make sure that the distance between the remote control (2) and the quadcopter
(1) is not more than 50m.
The quadcopter (1)
cannot be controlled.
Too strong a wind or draught. The quadcopter (1) is only suitable for calm conditions with no wind or up to force
3 winds.
The quadcopter (1) needs to be
calibrated.
Place the powered-on quadcopter (1) on a horizontal, level surface. On the pow-
ered-on remote control (2) simultaneously slide the throttle lever (2h) to the left and
back, and the control lever (2l) to the right and back.
The control lights (1h) on the quadcopter (1) will flash for approx. 3 seconds.
Once the control lights (1h) light up continuously, the calibration is complete and
the quadcopter (1) is ready to fly.
NOTE: repeat the calibration if the quadcopter (1) still flies erratically in one
direction.
The quadcopter (1) will
not fly upwards.
Not enough throttle. Slide the throttle (2h) forward completely.
The rechargeable battery (9) is flat. Charge the rechargeable battery (9).
The rotor protection (1c)
is not securely fixed.
Collision/crash. If a rotor guard (1c) becomes loose, tighten the screws again and double-check the
function and correct placement of the rotor guard (1c).
The quadcopter (1) lights
(1h) flash alternately.
Contact has not been established
between the quadcopter (1) and the
remote control (2).
Slide the throttle (2h) on the remote control (2) all the way forward, and then all
the way back.
This process establishes contact between the quadcopter (1) and the remote
control (2).
The rechargeable battery (9) is almost
flat.
Switch off the quadcopter (1) and remove the rechargeable battery, so it can be
charged.
… 19 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Crivit QUADROCOPTER - IAN 322151 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Crivit QUADROCOPTER - IAN 322151 in the language / languages: English, German, Dutch, French, Polish as an attachment in your email.

The manual is 5.19 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info