735864

Crivit Inshore 335 VII IAN 311071 Manual

19
Zoom out
Zoom in
Previous page
1/54
Next page
21
Assembling the double-bladed pad-
dle (fig. B)
1. Push a drip ring (8) over both ends of each
paddle tube so that the rings sit below the
locking button (6a) and the taper of the tube.
2. Insert the two paddle tubes (6) into the centre
section (7). In doing so, both locking buttons
(6a) must snap audibly and visibly with a
slight offset into the openings (7a) on the
centre section (7).
Note: You have the option of setting the paddle
at two different angles according to your prefer-
ence. When there are two people the paddles
can also be used without the centre section
individually as single-blade paddles.
Duffel bag
The product comes with a duffel bag (15) in
which the kayak can be stowed for transport
and for storage.
To close it use the 200cm cord (9a). The duffel
bag can also be used on board to keep provi-
sions, clothing, etc. protected against splash.
Note: Remember that the duffel bag is not
waterproof. Do not stow any sensitive items such
as cameras in the duffel bag.
For use on board remove the cord and roll the
top end up flat. Then close the duffel bag using
the hook-and-loop fasteners.
Storage bag
In addition, the product also comes with a
splash-proof storage bag (14) which is attached
to the back of the front seat (3) by the hook-and-
loop fasteners. Smaller items can be stowed in
the storage bag.
Note: Remember that the storage bag is not
waterproof. Do not stow any sensitive items in
the bag.
Disassembling the kayak
Remove the front seat, stern splash guard with
seat, bowsprit guard, and triangular cushion.
Deflating
Deflate the kayak as follows:
1. To deflate air chambers with stopper valves
pull the stopper valves (1d) out of the recesses
(fig. J) and press the stems together lightly or
use the deflation tube (12) (fig. M).
2. To deflate air chambers with screw-on valves,
unscrew the screw-on valves (10b) from the
base (1c) and let the air out completely
(fig. I).
Disassembling double-bladed pad-
dles
1. Push down the respective locking button.
2. Pull the two paddle tubes from the centre
section.
Note: The drip rings remain on the paddle
tubes.
Transport
The kayak should always be transported by two
people.
Storage, cleaning
WARNING!
Use only care products containing no
acid or petroleum components and nev-
er use silicon-based products.
Always store the product deflated, clean, and
dry at room temperature and out of the reach
of rodents. The valves should always be closed
during storage. Make sure that the product is
stored flat, not twisted.
1. Clean your kayak thoroughly each time after
use by rinsing it with clean water and mild
soap to get rid of salt crystals, grains of sand,
and other tiny contaminants. Then allow it to
dry completely.
2. Let the air out of all air chambers completely.
3. Lay the two upper side chambers inside the
kayak and then fold it up carefully.
Repairs
WARNING!
When there is more serious damage
you should not under any circumstance
perform repairs yourself.
You can repair minor damage with the repair kit
(13) supplied.
1. Let the air out of the kayak completely and
clean the location in question using an
alcohol-based solution. Use fine sandpaper to
roughen the area around the tear or hole.
GB/IE
… 19 …


Need help? Post your question in this forum.

Forumrules
1

Forum

crivit-inshore-335-vii-ian-311071

Reset search

  • Is there any way to get replacement parts as I have misplaced some. Submitted on 30-5-2023 at 22:56

    Reply Report abuse

  • Is there any way of getting some replacement parts as I have misplaced some of them Submitted on 30-5-2023 at 22:55

    Reply Report abuse


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Crivit Inshore 335 VII IAN 311071 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Crivit Inshore 335 VII IAN 311071 in the language / languages: English, German, Dutch, French, Polish as an attachment in your email.

The manual is 4,33 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info