Manual Crivit 7706 11000 IAN 108075 (page 7 of 49) (English, German, Dutch, Danish, French)

736623

Zoom out

Zoom in

1/49

7 GB/IE

Safety while operating

the appliance

Before putting the appliance into operation, en-

sure that the connection cable and plug are dry.

CAUTION! RISK OF FIRE! Never place the

appliance in direct proximity to naked ﬂames

or other sources of heat.

ATTENTION! RISK OF OVERHEATING!

Ensure the ventilation slits in the top of the cool

box lid are not covered, and that heat gener-

ated during operation can be dissipated ade-

quately. Ensure the appliance is situated at an

adequate distance (approx. 30 cm) from walls

or objects to allow air to circulate freely.

This appliance must not be exposed to rain.

Do not ﬁll any liquids or place any ice directly

into the inside of the appliance. If you do, this

could result in damage to the product.

Never immerse the appliance in water. If you

do, this could result in damage to the electrics.

When travelling by vehicle, do not transport

the appliance in the passenger compartment.

When operating the appliance, always ensure

that the 12 V plug is located ﬁrmly and safely

in the connection socket of the cigarette lighter,

and that the connection socket is free of dirt. If

the contact between the plug and socket is in-

adequate, vibration from the vehicle can cause

the power supply to switch on and oﬀ in short

bursts. This can result in overheating.

The manufacturer has no liability for damage

which is caused by improper use or incorrect

operation.

o not store in this appliance any materials, which

are potentially explosive, such as for example

aerosol cans with inﬂammable propellant gas.

General information on use

The coolbox is not suitable for continuous oper-

ation. Ice can form on the aluminium cooling

plate. We recommend that the coolbox is switche

oﬀ after it has been in operation for 6 days.

The coolbox can be put back into operation after

2 hours.

Dry the surfaces of your coolbox contents, so

that a build-up of condensation is avoided.

When the cool box is not in use, store the con-

nection cable inside the storage compartment

inside the cool box lid.

Be careful not to switch the vehicle engine on

and oﬀ frequently, so that the power supply to

the coolbox is not interrupted constantly. Also

be aware that the vehicle battery can be run

down too far, if the engine is switched oﬀ.

The recess on the inside of the cool box lid can

be used to store a standard 1.5 L bottle with a

headroom of max. 36.5 cm.

Operation

Before putting the coolbox into operation, we rec-

ommend for reasons of hygiene that it is washed in-

side and outside with a damp cloth (see also

chapter on „Cleaning and care“). Moreover don‘t

keep any unpackaged food in it.

Place the coolbox on a ﬁrm and level surface.

The connection cable is permanently connected

to the coolbox and can be found in the cable

compartment in the right, rear side of the appli-

ance.

Connect the 12 V connection cable to the socket.

The coolbox starts to work immediately (see

ﬁgure A).

Securing the cool

box lid with the handle

Fold the carrying handle

forward to close

the cool box lid

tightly (see ﬁgure B1).

Fold the carrying handle

up when trans-

porting the cool box. The cool box lid

closed tightly (see ﬁgure B2).

Fold the carrying handle to the back to open

the cool box lid

, (see ﬁgure B3).

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Crivit 7706 11000 IAN 108075 in the language / languages: English, German, Dutch, Danish, French as an attachment in your email.

The manual is 0,43 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Crivit 7706 11000 IAN 108075 Manual

Product: