736589
34
Zoom out
Zoom in
Previous page
1/38
Next page
-
65
-
Notes on calibration
A calibration for walking and running should always be performed. If you intend
to use the watch for walking only, then the watch must still be calibrated for
walking and running. In this case calibrate running as "fast walking".
If the pedometer is not calibrated it will use standard presets and the values shown
during your training may deviate strongly.
During the calibration phase the watch will record your personal movement
profile. The more evenly you move and the longer the recording time is, the better
the results will be during your training.
The calibration will allow the watch to automatically recognize if you are walking
or running, and adjust the displayed values accordingly.
The displayed values will be more exact if you move with the same rhythm and
speed as during the calibration.
During training, wear the watch on the same wrist as during calibration.
Calibration of the pedometer and setting the speed alarm (ZONE)
If necessary, press SET to stop a running pedometer measurement.
Press and hold SET for 3 seconds to enter setting mode.
The lower limit of the speed zone (UNTERES LIMIT/LOWER LIMIT) will blink on
the display. Set the lower limit by pressing SEL and confirm your setting by
pressing SET.
Set the upper limit (OBERES LIMIT/UPPER LIMIT) in the same way.
The calibration for running will now appear on the display "KALIBR.
LAUFEN/CALI FOR RUNNING". Select "JA/YES" by pressing SEL and confirm
your selection by pressing SET.
Now set the length of your calibration track (0.1 to 1km). Confirm your setting by
pressing SET.
Now press SET and run the entire length of the calibration track. After completing
the run press SET.
-
66
-
If the calibration was successful "KALIBR OK! SPEICH / CALI OK! SAVE" will
appear. If the calibration was unsuccessful "KALIBR. FEHLER / CALI FAILED" will
appear. In this case please repeat the calibration process.
"KALIBR. GEHEN / CALI FOR WALKING" will now appear on the display.
Complete the calibration for walking in the same way as the calibration for
running.
The calibration can be aborted by pressing MODE.
Exit setting mode by pressing MODE.
Odometer
(GESAMT-DIST/ODOMETER)
The bottom row of the display will show the total covered distance. The value can
be reset by pressing and holding SET.
Pedometer
(SCHRITTE/STEP)
The bottom row of the display will show the step count. The value can be reset by
pressing and holding SET.
Calories, fat burn and BMI
(KALORIEN/CALORIE)
The lower row will show the burned calories in kcal (KALORIEN/CALORIE).
Press SET to switch to the display of fat burn in gram (FETT/FAT BURN) or to the
display of your BMI (Body Mass Index).
In the display for calorie burn or fat burn the values can be reset by pressing and
holding SET.
Note: To increase the accuracy of the calorie and fat burn displays your age and
weight must be set correctly.
Note: The counter for fat burn is only activated while your heart rate is above 120
beats per minute.
34


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Crivit 1-LD3604-1 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Crivit 1-LD3604-1 in the language / languages: English, German, Dutch as an attachment in your email.

The manual is 0,96 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info