460638

Cresta WI2362 Manual

3
Zoom out
Zoom in
Previous page
1/5
Next page
Sports Car LED Alarm Clock Typ WI-2362
SETTING KNOBS & SWITCHES
1. ALARM HI/LOW/OFF SWITCH 5. ALARM SET BUTTON
2. TIME SET BUTTON 6. SNOOZE BUTTON
3. HOUR SET BUTTON 7. LED LIGHT
4. MINUTE SET BUTTON
POWER SUPPLY
Please check that the mains electricity power supply is the same as the AC rating indicated on the label
on the base of the clock.
INSTALLATION:
This unit operates by AC mains power supply. It also has a built-in battery backup facility, which
keeps the electronics clock working in the event of temporary power failure or disconnection from
the mains.
Place one 9 volt alkaline battery (type 522 or equivalent) into the battery compartment (located in
the bottom of unit) and connect the corresponding terminals, (battery not included). Set the
ALARM HI/LOW/OFF SWITCH (1) to "OFF" position.
Plug the AC line cord to a CONVENIENT AC power outlet and switch it on. The clock will flash on
and off until it has been set correctly. Flashing will also occur if the power supply is interrupted
when no battery is installed, or the battery is exhausted.
IMPORTANT
Do not install the clock where it can fall, or be pulled or pushed into water. Never reach for an
appliance after it has fallen into water. Switch off at the power point and unplug immediately.
SETTING THE NORMAL TIME
Hold down the TIME SET BUTTON (2)
Press the HOUR SET BUTTON (3) until the correct hour is shown on the clock display.
NOTE: PM time is indicated by the PM light.
Press the MINUTE SET BUTTON (4) until the correct time appear on the clock display.
Release the buttons as time is set precisely.
TO SET WAKE TO ALARM
Slide the ALARM HI/LOW/OFF SWITCH (1) to the required position.
Press and hold down the ALARM SET BUTTON (5), and while this button is depressed, press the
HOUR SET BUTTON (3) and then the MINUTE SET BUTTON (4) until it reaches the time which you
wish to wake up. The wake up time is entered in its memory.
Release the ALARM SET BUTTON (5).
The alarm and the LED LIGHT (7) will switch on automatically at the pre-set wake up time.
You can check the pre-set wake up time by pressing the ALARM SET BUTTON (4) at any time.
NOTE: This pre-set wake-up time will remain or continue to be restored in the time memory as long
as the clock is connected to the power supply, and the Alarm will switch on by itself at the same time
next day.
SNOOZE CONTROL AND TO STOP THE ALARM
Press the SNOOZE BUTTON (7) to stop the Alarm for a while, however, it will repeat after 9
minutes.
If you do not need the Alarm, simply switch the ALARM HI/LOW/OFF SWITCH (1) to “OFF” position.
If you wish the Alarm function again, switch it to “HI/LOW” position.
TO OPERATE THE HI/LOW ALARM
Switch the ALARM HI/LOW/OFF SWITCH (1) to the “HI/LOW” position, the Clock will operate the
Tone alarm automatically.
BATTERY BACKUP
By installing a 9 volt battery as described previously, the clock will continue to operate in the event
of a short temporary power failure or temporary disconnection of the power cord.
The clock display will not light up, and the Alarm will not function while the AC mains power supply
is interrupted.
The battery backup system is useful for short, temporary power failures. If main power is
disconnected for longer duration, the battery may become exhausted, or there may be some loss of
timing accuracy. When the battery is exhausted, it should be removed from the set, to prevent
damage from leakage.
If you do not wish to use the battery backup, the clock will operate normally without a battery.
However, if disconnected from the main supply, the clock display will flash when the power is
reconnected and the clock must be reset as described earlier.
ENGLISH-1
ENGLISH-2
3


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Cresta WI2362 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Cresta WI2362 in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 0,19 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info