Clean the hob regularly and wipe up spills soon after they occur to prevent them from
becoming burnt on.
1. Household abrasive powders, e.g. Vim.
2. Oven chemical cleaners, aerosols and oven pads.
Caustic cleaners such as these will etch the surface and attack the metal frame.
3. Bath and sink cleaners may mark the surface.
Wipe with a cloth wrung out in hot soapy water. Stubborn stains can be removed with
a cream paste or liquid cleaner.
Wipe with a cloth wrung out in hot soapy water followed by a wipe with a cloth wrung
out in clear water and then dried with a soft clean cloth.
Wipe with a cloth wrung out in hot soapy water only; do not use abrasives. Use a
nylon brush to remove any cleaning materials, water or dirt from the burner bodies.
Re-assemble as in the diagram below.
Wipe over the knobs with a soft cloth wrung out in hot soapy water or mild non-abra-
sive cleaner. Then, after wiping with a cloth wrung out in clear water, dry with a soft
clean cloth.
Never use scouring pads or abrasive cleaners/powders which may scratch the
surface.
CARE AND CLEANING
SWITCH OFF THE ELECTRICITY SUPPLY BEFORE CLEANING.
BEFORE SWITCHING ON AGAIN, ENSURE THAT ALL
CONTROLS ARE IN THE OFF POSITION.
NEVER USE BIOLOGICAL WASHING POWDER, HARSH
ABRASIVES, SCOURING PADS, AEROSOL CLEANERS OR
OVEN CHEMICAL CLEANERS OF ANY KIND.
CLEANING MATERIALS TO AVOID
7
CONTROL KNOBS.
ALUMINIUM BURNER BODIES AND RINGS.
VITREOUS ENAMEL HOB, PAN SUPPORTS AND BURNER CAPS.
STAINLESS STEEL.
BURNER ASSEMBLY
