Manual Creda W100FW (page 4 of 16) (English)

498194

Zoom out

Zoom in

1/16

Connect to a drainage system

● Do not remove hooked end support from drainage hose.

● Do not position standpipe near an electrical outlet.

For drainage into a standard work top sink ensure outlet pipe has a minimum bore of

32 mm. To avoid syphoning ensure the end of the drainage hose is above the water level

in the sink.If your sink is inset, the front edge of the basin must be less than 75 mm from

the front edge of your work top.

We recommend one of the following methods:-

Into a Standpipe

Ensure the standpipe has a minimum bore of 38mm (1

⁄2”).

1. Ensure the top of the standpipe is at least 500mm

(20”) from the floor.

2. Untie GREY drainage hose and place approximately 100mm (4”) into the standpipe.

3. If the end of your GREY drainage hose is fitted with ‘Retaining Flaps’ ensure they are

fully inserted into the standpipe as shown (Fig.2)

Into a Sink Waste System

Ensure the sink outlet pipe has a minimum diameter of 32mm (1

⁄4

”).

1. Untie drainage hose from rear of the appliance.

2. Reposition the Hooked End Support as required along the GREY drainage hose.

If fitting an under sink waste disposal unit (Fig 3)

, cut out the membrane or blanking

plug.

4. Attach the end of the GREY drainage hose to the undersink waste disposal securely

as shown using a hose clip (Fig 4).

5. Raise the hose to a minimum height of 800 mm to avoid syphoning.

500 mm

Fig 1

Fig 3

Cut

Fig 2

Hose Clip

Fig 4

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Creda W100FW in the language / languages: English as an attachment in your email.

The manual is 0,55 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Creda W100FW Manual

Product: