498201
6
Zoom out
Zoom in
Previous page
1/24
Next page
iii. Connect to the Water Supply...
Water taps and standpipe should be situated away from the rear of appliance but in easy
access for turning on and off.
For your machine to operate correctly it requires water pressures in the range of 6-150 psi
(100 - 1000KPa). Most water supplies will be in this range.
Connect the hoses to the water supply pipes at the rear of the appliance
and onto the water supply taps (Red end fitting to the hot water supply
and adjacent to ‘H’on the rear of the appliance and White end fitting to
the cold water supply and adjacent to ‘C’ on the rear of the appliance).
Remember to insert a sealing washer (A) to ensure each connection is
watertight.
Fit securely and turn on the water supply to check for leaks.
If there is a leak, turn off the water supply, remove the connector
and check that the sealing washer is in place. Refit the connector
and tighten it. Turn on the water supply.
Note: Do not over tighten the water supply pipe connection. Hand
tight should be sufficient.
We recommend you use the new hoses provided with your appliance to ensure correct
connections and prevent leaks.
WARNING
Do not connect
appliance to a single
outlet instantaneous
water heater.
6
Remember you may be
charged for a service
call if a problem with
your appliance is
caused by incorrect
installation or misuse.
If the fill hoses are too short:
If you have no hot water supply or your hot water pressure is low:
Longer fill hoses are available from our Genuine Parts and
Accessories Mail Order Hotline
UK on 08709 077 077
(or in the Republic of Ireland on (01) 842 6836).
Remove the existing fill hoses from the inlet valves on the
back of the machine and fit the new longer fill hoses as shown
with the angled ends of the hoses connected to the machine.
A cold fill adaptor and fitting instructions are available from
your local Creda authorised Service Centre or by calling the
Genuine Parts and Accessories Mail Order Hotline
UK on 08709 077 077
(or in the Republic of Ireland on (01) 842 6836).
A cold fill adaptor
6


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Creda IWM1 2 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Creda IWM1 2 in the language / languages: English as an attachment in your email.

The manual is 1,71 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info