498202
5
Zoom out
Zoom in
Previous page
1/24
Next page
i.Remove Transit Screws...
BEFORE ATTEMPTING TO USE THE MACHINE,YOU MUST FOLLOW THE PROCEDURE DESCRIBED BELOW.
The inside of the appliance is supported, for transportation, by four screws on the back panel. Before
using the appliance these MUST be removed. NOTE: You may need a second person to help you.
Remove the screws , along with the
spacers together with the washers
intact.
You must now cover the holes with the
four plastic covers provided.
The choice of location for your appliance will influence its performance.
Position where possible on a solid floor.Vibration may occur with a wooden floor.
Take care with vinyl floor coverings.The weight of the appliance may cause indentations in some
vinyl floor coverings.
You should not install your appliance on a carpeted floor, but if this is unavoidable, ensure that air
can circulate around its base.
If locating next to another appliance or an item of furniture, leave space between them to allow air
to circulate.
For your safety and to comply with IEE regulations, you should not install your appliance in a bath
or shower room. Seek professional advice if you wish to do so.
Ensure sufficient space is allowed for the appliance.
Ensure the electrical socket and water taps are easily accessible and that the water supply can be
isolated if necessary.
Risk of freezing: Do not position the appliance in rooms exposed to frost.
Frozen pipes may burst under pressure.
ii. Choose a Location...
5
1.
2.
Important: Use the cap supplied to close the 3 holes which housed the plug, situated in the
right hand part of the lower back of the appliance.
WARNING:
The appliance must not
be plugged into the
mains supply until all
installation instructions
have been completed.
Retain the transit
screws, spacers and
washers. Should you
move house then these
should be replaced to
support the inside of the
appliance to prevent
damage when in transit.
5


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Creda IWD1 2 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Creda IWD1 2 in the language / languages: English as an attachment in your email.

The manual is 1,71 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info