818974
15
Zoom out
Zoom in
Previous page
1/340
Next page
5. Remove the blade nut, spacer, blade insulator, and blade.
6. Thread the blade nut on the shaft and finger tighten.
7. Torque the blade nut down clockwise using a torque wrench (not provided) to ensure the bolt is properly
tightened. The recommended torque for the blade nut is 90 N.m~100N.m (66~74 ft.lbs).
WARNING
Ensure blade is properly seated and the blade nut is tightened to the torque specifications above. Failure to
properly attach the blade could cause it to come loose and result in possible serious personal injury.
8. Repeat with second blade, if needed.
NOTE
Make certain all parts are replaced in the exact order in which they were removed.
7.2 REPLACE THE HEADLIGHT
See figure 18
Call customer service or visit our website online to order a new headlight.
1. Park the mower on a level surface and set the parking brake.
2. Stop the motor and remove the start key.
3. Remove and set aside the hex head screw and flat washer holding the mower floor panel in place.
4. Lift floor panel slightly to access the two hex head screws and flat washers securing the headlight in place.
Remove screws and washers and set aside.
5. Unplug the old headlight and discard.
6. Plug in new headlight and reinstall washers and screws. Tighten securely.
7. Lower floor panel and reinstall washer and screw to secure.
7.3 TIRES
It is important for level mowing that all tires have the correct amount of air pressure. The recommended pressure are:
NOTE
Tire pressure should only be measured or adjusted when tires are cold.
Drive wheels 8 psi
Front caster wheels 24 psi
NOTE
Inspect the tires daily. Replace immediately if damaged.
WARNING
Check the tire pressure carefully while inflating. Too much air in the tire could cause the tire to burst, causing
serious personal injury.
7.4 LUBRICATION
See figure 19
Please add oil before operation.
Oil type SAE85W-140
Oil capacity 180 ml
Contact your Cramer dealer to replace the lubrication.
15
English EN
15


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Cramer 82LT107 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Cramer 82LT107 in the language / languages: All languages as an attachment in your email.

The manual is 7.07 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info