601724

Cordo CRD 4 Manual

2
Zoom out
Zoom in
Previous page
1/2
Next page
Totaal afstand
• MODE indrukken tot (Totaal-afstand) verschijnt.
• Achterzijde: SET 3 sec indrukken ( knippert).
• Met MODE cijfers instellen.
• Met SET bevestigen enz.
• Met MODE getallen instellen. Na het laatste cijfer met SET bevestigen.
Total distance
• Press MODE until (total distance) appears.
• Press SET on the back for 3 sec ( flashes).
• Enter number with MODE.
• Confirm with SET and go to the next position.
• Enter next number with MODE. Confirm and quit with SET after the last position.
1 0 0 3 7
1 0 0 3 7
1 2 ...8 ...0
Reset de Display
• MODE langer dan 1 seconde ingedrukt houden.
• Melding knippert. Na 2,5 seconde wordt
(Dagafstand) en (Rit-tijd) teruggezet op 0.
Reset the displays
• Keep MODE pressed down for longer than 1 second.
•Display flashes. After 2.5 seconds
(Trip distance) and (Ride time) are reset to 0.
Algemene opmerkingen
Batterij: 1 Lithium type 2032.3V. Wissel de batterijen na 3 jaar of eerder als de
batterijen zwakker worden. Batterijdeksel met munt openen.
Batterijen wisselen:
• Voor het wisselen van de batterijen noteer de wielomtrek en de Totaalafstand.
• Let op Plus en Min, bij het afnemen van de deksel moet de Plus van de batterij
zichtbaar zijn.
• Dichtingsring goed plaatsen.
• Na het verwisselen van de batterijen moeten de Totaalafstand, de Wielomtrek en Klok
opnieuw worden ingesteld. De display gaat automatisch naar instelling van de Taal
en Wielomtrek.
Garantie: Hier gelden de voorgeschreven garantie bepalingen.
General remarks
Battery: 1 lithium type 2032, 3V. Change batteries after appr. 3 years or as soon as the
display fades. Open the battery compartment cover with a coin.
Changing batteries:
• Before changing take note of wheel size and total distance.
• Observe plus and minus. When battery compartment is open, you should see the
plus pole!
• Refit rubber seal if detached.
• After change of batteries total distance, wheel size and clock must be re-entered.
Set language is shown as first value on the display.
Warranty: The legal warranty regulations are valid.
Probleemoplossingen
KMH geen display aanduiding
• Metaal huls over de magneet geschoven? (beeld 9)
• Is de wielomtrek goed ingesteld?
• Is de computer goed in de houder bevestigd?
• Oxidatie van batterijen of contacten?
• Kabelbreuk ?
• Afstand magneet en sensor oké (max 5 mm)
• Is de magneet nog gemagnetiseerd?
Display geen beeld
• Batterij in orde?
• Batterij goed gemonteerd? Opletten! Plus/Min
• Batterij contacten oké? Zonodig voorzichtig bijbuigen
KMH klopt niet
• 2 magneten gemonteerd?
• Magneet goed gemonteerd?
• Wielomtrek goed ingesteld?
Display zwart
• Alleen bij directe zonnestraling >60°C. Bij afkoeling weer normaal!
Display traag
• Alleen bij temperaturen onder de 0°C. Bij hogere tempuren normaal beeld!
Problem solutions
No speed display
• Safety shell is pushed over the magnet (fig. 9)?
• Is the entered wheel size correct?
• Is the computer properly placed in the bracket?
• Did you check the contacts for oxidation/corrosion?
• Check the cable for damage.
• Did you check the distance? (max. 5 mm/0,2 inch)
• Is the magnet magnetizised?
Display is empty
• Check the battery
• Did you put the battery in the right way? (pay attention to plus and minus)
• Check contacts, bend if necessary
KMH display is wrong
• Did you assemble 2 magnets?
• Is the magnet positioned in the right way?
• Did you enter the correct wheel size?
Display is black
• Only in direct sunlight (>60°C), under 60°C the display will return to normal.
Display is sluggish
• Only at temperatures under 0°C, display will be normal after warm up.
Instellen van de klok
• Druk op MODE tot (KLOK) verschijnt
• Aan de achterzijde SET 3 sec ingedrukt houden.
• Met MODE uren instellen.
• Met MODE van uren naar minuten wisselen.
• Met RESET minuten instellen en met SET bevestigen, instel modus verlaten.
Set clock
• Press MODE until (CLOCK) appears.
• Press SET on the back for 3 sec. with a pointed tool.
• Enter the hours with MODE.
• Confirm with SET and go to minutes.
• Enter minutes with MODE. Confirm and quit with SET.
www.cordo.nl
Cordo is de lijn fietsaccessoires van AGU BV, Alkmaar - Nederland
2


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Cordo CRD 4 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Cordo CRD 4 in the language / languages: English, Dutch as an attachment in your email.

The manual is 0,34 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info