751433

Corbero CLVG6048W Manual

36
Zoom out
Zoom in
Previous page
1/42
Next page
15
14
Intensive
Crystal
Rapid
Programme)
(Standard
WARNING!
- Capacity: 12 settings
- Position of upper basket: Low position
- Rinse aid setting: 5 (or 4 for four setting dispenser)
6. Starting a Washing Programme
Wash cycle table
Program
Cycle Selection
Information
Description
of Cycle
Detergent
Pre/main
Running
Time(min)
Energy
(kWh)
Water
(L)
For the heaviest soiled loads,
such as pots, pans, casserole
dishes and dishes that have
been sitting with dried food
on them for a while.
For normally soiled loads,
such as pots, plates, glasses
and lightly soiled pans.
standard daily cycle.
For lightly soiled loads, such
as plates, glasses, bowls and
lightly soiled pans.
Light wash cycle to be used
for more delicate items which
are sensitive to high
temperatures.(Run cycle
immediately after use)
A shorter wash for lightly
soiled loads that do not
need drying.
To rinse dishes that you
plan to wash later that day
Pre-wash
Main wash(60℃)
Rinse1
Rinse2
Hot rinse
Drying
Pre-wash
Main wash(46℃)
Hot rinse
Drying
Pre-wash
Main wash(45℃)
Rinse
Hot rinse
Drying
Main wash(40℃)
Rinse
Hot rinse
Drying
Main wash(40℃)
Hot rinse
Pre-wash
4/16
4/16
3/15
3/15
15
180
237
137
124
39
11
16
11
14
9
7
4
1.30
0.922
0.85
0.80
0.50
0.01
Starting a wash cycle...
Draw out the lower and upper basket, load the dishes and
1. push them back. It is recommended to load the lower basket first, then the upper one (see the
section entitled "Loading the Dishwasher"). Pour in the detergent (see the section entitled "Salt,
Detergent and Rinse Aid").
2. Insert the plug into the socket. The power supply is 220-240V AC 50 Hz, the specification of the
Turning on the Appliance
Light
Pre-Rinse
Eco
(*E 60436)
It is dangerous to open the door when washing, because the hot water may scald you.
Switch Off the Dishwasher
The digital display appears "--" and the buzzer rings 6 times, only in this case the programme
has ended.
1.Switch off the dishwasher by pressing the ON/OFF button.
2.Turn off the water tap!
Open the door carefully. Hot steam may escape when the door is opened!
■Hot dishes are sensitive to knocks. The dishes should therefore be allowed to cool down around
15 minutes before removing from the appliance.
■Open the dishwasher's door, leave it ajar and wait a few minutes before removing the dishes. In
this way they will be cooler and the drying will be improved.
Unloading the dishwasher
It is normal that the dishwasher is wet inside.
Empty the lower basket first and then the upper one. This will avoid water dripping from the upper
basket onto the dishes in the lower one.
Switching on
1. Open the tap, if it is closed.
2. Close the door.
3. Make sure the spray arms are not obstructed.
4. Switch the dishwasher on using the ON/OFF button.
Select a programme
Choose your programme according to the type of load and how dirty it is.
The different programmes and their uses are described in the programme chart later on in this
booklet. Use the programme selector to select the expected programme .
Change the Programme.
Premise: A cycle that is underway can only be modified if it has only been running for a short time.
Otherwise, the detergent may have already been released, and the appliance may have already
drained the wash water. If this is the case, the detergent dispenser must be refilled (see the section
entitled " Fill in the Detergent " ).
1:Press the " ON/OFF" button or " Reset" button 3 seconds(dishwasher with " reset" button) to cancel
the programme.
2: Turn on it again. Then rotate the programme selector to the expected cycle setting (see the section
entitled "Starting a wash cycle. . . " ).
NOTE: If you open the door when the washing cycle underway, the appliance will pause and emit
warning signals, the digital display show " E1" and flash. When you close the door, the machine will
keep on working after 10 seconds.
Forget to Add Dish
A forgotten dish can be added any time before the detergent cup opens.
1 Open the door a little to stop the washing.
2 After the spray arms stop working, you can open the door completely.
3 Add forgotten dishes.
4 Close the door, the dishwasher will work after ten seconds.
Cycle Table".)
With a little force to ensure the door is properly closed.
NOTE: A click could be heard when the door is closed perfectly.
When the washing is over, you can shut off the switch by pressing ON/OFF button.
N
socket is 12 A 250 VAC.50 Hz.
Make sure that the water supply is turned on to full pressure. Open the door, press the ON/OFF
button, Press the "program." button to select a desired "Wash cycle". (See the section entitled "Wash
EN 60436: this program is the test cycle
The information for comparability test in accordance with EN60436, as follows:
1.The ECO program is suitable to clean normally soiled tableware,it is the most efficent program in
terms of its combined energy and water consumption
2 Manual pre-rinsing of tableware items leads to increased water and energy consumption and is not
recommended .water and energy consumption and is not recommended .
3 Washing tableware in a household dishwasher usually consumes less energy and water than hand
dishwashing when the household dishwasher is used according to this instruction manual.
… 36 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Corbero CLVG6048W at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Corbero CLVG6048W in the language / languages: English, Spanish as an attachment in your email.

The manual is 14,05 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info