equipment that could be sensitive to external RF energy.
HEARING AIDS
Some digital wireless phones may interfere with some hearing aids. In the event of such interference, you may
want to consult your service provider, or call the customer service line to discuss alternatives.
NON-IONIZING RADIATION
Your device has an internal antenna. This product should be operated in its normal-use position to ensure the
radiative performance and safety from interference. As with other mobile radio transmitting equipment, users
are advised that for satisfactory operation of the equipment and for personal safety, it is recommended that no
part of the human body be allowed to come too close to the antenna during operation of the equipment.
Use only the supplied integral antenna. Use of unauthorized or modified antennas may impair call quality and
damage the phone, causing loss of performance and SAR levels exceeding the recommended limits, as well as
result in non-compliance with local regulatory requirements in your country. To assure optimal phone
performance and ensure human exposure to RF energy is within the guidelines set forth in the relevant
standards, always use your device only in its normal-use position.
Contact with the antenna area may impair call quality and cause your device to operate at a higher power level
than needed.
Avoiding contact with the antenna area when the phone is in use optimizes the antenna performance and the
battery life.
BATTERY INFORMATION AND PRECAUTIONS
To assure product safety, there shall be precautions below.
! Danger
- Use dedicated chargers and follow the specified conditions when charging the cell.
- Use the cell only in the specified equipment.
- Do not heat or put the cell into the fire. Do not wet the cell.
- Do not use, leave cell close to fire or inside of a car where temperature may be above 60°C. Also do not
charge /discharge in such conditions.
- Do not put or store cell together with metal articles such as necklaces, hairpins, coins, or screws.
- Do not short circuit the (+) and (-) terminals with metal conductors.
- Do not place cell in a device with the (+) and (-) in a reverse way.
- Do not penetrate cell with a sharp articles such as a needle.
- Do not disassemble the cell.
- Do not weld the cell directly.
- Do not use a cell with serious scar or deformation.
